Abstract:Electronic power transformers (EPTs) have been identified as emerging intelligent electronic devices in the future smart grid, e.g., the Energy Internet, especially in the application of renewable energy conversion and management. Considering that the EPT is directly connected to the medium-voltage grid, e.g., a10 kV distribution system, and its cascaded H-bridges structure, the common mode voltage (CMV) issue will be more complex and severe. The CMV will threaten the insulation of the entire EPT device and even produce common mode current. This paper investigates the generated mechanism and characteristics of the CMV in a cascaded H-bridge EPT (CHB-EPT) under both balanced and fault grid conditions. First, the CHB-EPT system is introduced. Then, a three-phase simplified circuit model of the high-voltage side of the EPT system is presented. Combined with a unipolar modulation strategy and carrier phase shifting technology by rigorous mathematical analysis and derivation, the EPT internal CMV and its characteristics are obtained. Moreover, the influence of the sinusoidal pulse width modulation dead time is considered and discussed based on analytical calculation. Finally, the simulation results are provided to verify the validity of the aforementioned model and the analysis results. The proposed theoretical analysis method is also suitable for other similar cascaded converters and can provide a useful theoretical guide for structural design and power density optimization.

Modeling and Evaluation of Common-Mode EMI Coupling Through Converter Chassis in Metro Traction System

Modeling And Characterization Of Incomplete Shielding Effect Of Gnd On Common-Mode Emi Of A Power Converter

Common Mode Interference Modeling and Measurement for Cascaded Photovoltaic Grid-Connected System Module

A Fast EMI Model Based on Equivalent Interference Sources in Medium-Voltage Cascaded H-Bridge System

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

Model of EMI coupling paths for an off-line power converter

Determining Far-Field EMI From Near-Field Coupling of a Power Converter

Identification of Essential Coupling Path Models for Conducted EMI Prediction in Switching Power Converters

An Evaluation Method of Transformer Behaviors on Common-Mode Conduction Noise in SMPS

Transfer network models for EMI coupling paths characterization of multiconductor cables

Modeling And Analysis Of Conducted Emi For A Modular Multilevel Converter

Modeling and analysis of electromagnetic interference from connectors in communication chassis

Modeling and Simulation of Conducted EMI for Front-End Power Supply

Modeling and Measurement of the Impedance of Common Mode Noise Source of Switching Converters

Conducted EMI Model and Coupling Resonant Mechanism Analysis of Multi-Cell Converter System

Noise Source Lumped Circuit Modeling and Identification for Power Converters

Common-Mode Conducted EMI Prediction for Dual Active Bridge Converter Based on Unterminated Behavioral Model

Modeling and Analysis of the Common Mode Voltage in A Cascaded H-Bridge Electronic Power Transformer

The Electromagnetic Interference (EMI) affect on power supply of telecom equipment

EMI Behavioral Model Based CM Noise Prediction Method for DC Power System Considering Multi-Noise Coupling

Modeling and Reduction of Conducted Common Mode EMI in A-Single-switch Forward Converter