Abstract:Compared with isolated converters, transformerless converters are a preferred choice in low-voltage grids due to their efficiency and lower cost. However, leakage current and common mode (CM) voltage appear through the converter and ground in hybrid grids, which consist of AC and DC subgrids. The leakage current and CM voltage seriously influence operation and power quality in low-voltage distribution systems. This paper proposes a common-ground-type (CGT) converter equipped with a CM decoupling control strategy to eliminate the leakage current and CM voltage. A CM model is derived, and the leakage current and CM voltage are analyzed in detail. A CGT four-leg converter is constructed to eliminate the high frequency CM voltage. A dual DQ current control loop is developed to suppress the DC double-frequency ripple. Additionally, an active damping method is proposed, based on the neutral current feed-forward plus inductor current feedback, to attenuate the low frequency CM voltage. The proposed converter and control strategy guarantees excellent performance in suppressing leakage current and CM voltage. The DC voltage of the converter connected to the DC grid maintains stability and symmetry. The leakage current is significantly reduced, and the leakage current suppression performance is improved by 83%. The high frequency CM voltage is attenuated from 50%udc to 2%udc, and the low frequency CM voltage is suppressed from approximately 32%udc to 3%udc, which is a significant improvement compared with the traditional method. In addition, the proposed control strategy has good transient performance when the load changes abruptly. Finally, an experimental platform is established to validate the feasibility and performance. The experiment results showed that the proposed control strategy improves the system performance and power quality.

Transformer Structure of Bifilar Primary Winding with Advanced Common Mode Noise Attenuation Performance for Isolated DC-DC Converters

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

Design of Transformer Shielding Foil Structure for Minimizing Common-Mode Noise in LLC Resonant Converters

Design of the Number of Transformer Shielding Winding Turns for Minimizing Low-Frequency Common-Mode Noise in Flyback Converters

Suppressing Methods of Common-Mode Noise in LLC Resonant DC-DC Converters

Magnetic Integration Structure for Two-Stage DC-DC Converters

A High Power Density 48V-12V DCX with 3-D PCB Winding Transformer

Common-Mode Noise Mitigation Method for Planar Transformer Based on FB LLC Converter

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Winding Loss Reduction Based on the Even Magnetomotive Force in the Wide-Range RDCX Converter for OBC

Design of coaxial transformer for modular isolated DC/DC converters

Modeling and Design of Integrated Inductor and Transformer Considering Superposed Flux Density in On-Board-Charger

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter

Research on the Transformerless Connection Mode for DC Power Distribution System

Analysis and Reduction of Common-mode Noise in Cellular RDCX Converter

Analysis and Reduction of Common Mode Current of the Transformer in a Full-Bridge LLC Battery Charger

Magnetic Coupling Common Mode Conducted EMI Analysis and Improvement in a Boost Converter

High Power Density 48–12 V DCX with 3-D PCB Winding Transformer

Common-Mode Current Suppression of Transformerless Nested Five-Level Converter with Zero Common-Mode Vectors

Impedance-Balancing-based Modulation Strategy for Common-Mode Noise Elimination of CHB Converter

A Transformerless Converter with Common-Mode Decoupling in Low-Voltage Hybrid Grids