Abstract:Due to the rapid adoption of Electric Vehicles (EVs) worldwide, On-Board/Off-Board Battery Chargers are facing numerous. One challenge is charging time since petrol and diesel vehicles are charged 10 times faster than electric vehicles. A second challenge is power density especially for the on-board chargers where minimal space for installation is allocated inside the vehicles. Another challenge is the wide battery voltage range which makes it difficult to optimize the converter over the entire battery voltage range and efficiency drops when either the battery voltage is too high or too lo.. Finally, the bi-directional operation is a challenge to allow the EV to support the grid in peak periods or even standalone loads. In this paper, a 6.6 kW two-stage structure is proposed utilizing a variable dc-link voltage operation. One of the most promising challenges in high-power applications is implementing the magnetics component into Printed Circuit Boards (PCBs). PCB winding transformers are widely in use in low power applications. Compared with conventional Iitz-wire transformers, the manufacturing process is greatly simplified and the parasitic is easier to control. However, due to the limitation of high winding loss and high multi-layer PCB cost in high power applications, the transformer design with PCB winding becomes a challenge. Emerging wide-bandgap devices provide the opportunity to adopt PCB transformers into high power applications. In addition, the low inductance requirement brought by high frequency also makes possible the realization of magnetic integration in PCB transformers.

A High Power Density 48V-12V DCX with 3-D PCB Winding Transformer

High Power Density 48–12 V DCX with 3-D PCB Winding Transformer

A novel PCB winding transformer with controllable leakage integration for a 6.6kW 500kHz high efficiency high density bi-directional on-board charger

High Efficiency High Power Density Cellular 1mhz 380V-12V DCX for Future Data Centers

A WBG based three phase 12.5 kW 500 kHz CLLC resonant converter with integrated PCB winding transformer

High-Frequency High-Density Bidirectional EV Charger

A High Density 400 W DC/DC Power Module with Integrated Planar Transformer and Half Bridge GaN IC

Magnetic Integration Structure for Two-Stage DC-DC Converters

An Optimization Method for Planar Transformer Winding Losses in GaN Based Multi-output Flyback Converter

Power Decoupling Three-Port Converter with Integrated Transformer

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

1 MHz 48–12 V Regulated DCX with Single Transformer

Modeling and Design of Integrated Inductor and Transformer Considering Superposed Flux Density in On-Board-Charger

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

High-Density Planar Integrated Magnetics with Two-Sided Merged Inductor Windings and Integrated Cores for Resonant DC/DC Converter

High-Frequency PCB Winding Transformer With Integrated Inductors for a Bi-Directional Resonant Converter

A 1.8kw/in3 Power Density Cellular 380V-12V DCX with 98.4% Peak Efficiency Using Low NFoM Devices and Resonant Drive Transformer

High-Efficiency High-Density MHz Cellular DC/DC Converter for On-Board Charger

A High Power Density And Efficiency Bi-Directional Dc/Dc Converter For Electric Vehicles

Design and Optimization of High Insulation Voltage Planar Transformer for DC-DC Converters

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density