Abstract:Due to the rapid adoption of Electric Vehicles (EVs) worldwide, On-Board/Off-Board Battery Chargers are facing numerous. One challenge is charging time since petrol and diesel vehicles are charged 10 times faster than electric vehicles. A second challenge is power density especially for the on-board chargers where minimal space for installation is allocated inside the vehicles. Another challenge is the wide battery voltage range which makes it difficult to optimize the converter over the entire battery voltage range and efficiency drops when either the battery voltage is too high or too lo.. Finally, the bi-directional operation is a challenge to allow the EV to support the grid in peak periods or even standalone loads. In this paper, a 6.6 kW two-stage structure is proposed utilizing a variable dc-link voltage operation. One of the most promising challenges in high-power applications is implementing the magnetics component into Printed Circuit Boards (PCBs). PCB winding transformers are widely in use in low power applications. Compared with conventional Iitz-wire transformers, the manufacturing process is greatly simplified and the parasitic is easier to control. However, due to the limitation of high winding loss and high multi-layer PCB cost in high power applications, the transformer design with PCB winding becomes a challenge. Emerging wide-bandgap devices provide the opportunity to adopt PCB transformers into high power applications. In addition, the low inductance requirement brought by high frequency also makes possible the realization of magnetic integration in PCB transformers.

High Efficiency High Power Density Cellular 1mhz 380V-12V DCX for Future Data Centers

A 1.8kw/in3 Power Density Cellular 380V-12V DCX with 98.4% Peak Efficiency Using Low NFoM Devices and Resonant Drive Transformer

Modular High Efficiency High Density MHz DCX with Different Output Voltage Adaptation

A High Power Density 48V-12V DCX with 3-D PCB Winding Transformer

High-Efficiency High-Density RDCX Modules Cascaded with CHB PFC Stage

High Power Density 48–12 V DCX with 3-D PCB Winding Transformer

1 MHz 48–12 V Regulated DCX with Single Transformer

A 98.4% Efficiency 380V-12V DCX with 1.3kw/in3 Power Density Using Low NFoM Devices and Resonant Drive Transformer

High-Efficiency High-Density MHz Cellular DC/DC Converter for On-Board Charger

A High Density 400 W DC/DC Power Module with Integrated Planar Transformer and Half Bridge GaN IC

A WBG based three phase 12.5 kW 500 kHz CLLC resonant converter with integrated PCB winding transformer

High Efficiency High Density 1 MHz 380–12 V DCX with Low FoM Devices

Analysis of MHz 380V-12V DCX with Low FoM Device

High-Frequency High-Density Bidirectional EV Charger

MHz Level Two-Stage ZVS DC-DC Converter with Wide Input and Output Voltage Ranges

Light-Load Efficiency Improvement of MHz RDCX Based on Output Voltage Ripple and Resonant Pulse Number Control

Low Common Mode Noise Cellular RDCX with Single Bus Multi-Level Regulator

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

A MHz Regulated DC Transformer with Wide Voltage Range

A High Power Density And Efficiency Bi-Directional Dc/Dc Converter For Electric Vehicles

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion