Abstract:With the development of analytical instrumentation to minimization,integration and automation,the microfluidic chips,which are more integrated,complex and diversified,have been applied widely on the manufacturing of analytical instrumentation.However,the present photolithography-based microfabrication technology,which is only able to pattern microchannels with simple inside structures,can not follow the rapid development of requirements.For solving the problem,a fabrication method based on the restricting effect of laminar flow is proposed for the micro etching on isotropic substrates.Experiments were conducted inside glass-based microchannels,in which certain etchant was used to form complicated microstructures.The flow parameters’ effects on the aspect ratio,side wall profile and etching rate were revealed by the experiments.The experimental results reveal that the topography of micro structures patterned with the restricted flow etching method is mainly determined by the flowrates of separator and etchant.The computational fluid dynamics（CFD） model on the interface between multiple streams was established for the etching process,and analysis on the causes of various micro topographies was conducted based on the CFD simulation results.The experimental data consisted with the simulation results very well.The investigation depicted in this paper indicate that the flow restricted etching method provides sufficient references for the research and understanding on the mass transport at the liquid-liquid surface in the microchannel and can be used to pattern complex micro structures with high aspect ratios,meantime,it greatly enriches the microfabrication technology for microfluidic chips.

Innovative Two-Step Method for Efficient Silicon Microfluidic Device Fabrication: Integrating Laser Ablation with Wet Etching

Simple and Cost-Effective Fabrication of Two-Dimensional Plastic Nanochannels from Silica Nanowire Templates

Micro Etching Method Inside Microchannels

Fabrication of Optofluidic Systems Using Isotropic Wet Etched Masters in < 111 > Silicon Wafer

Laser Lithography of Monolithically‐Integrated Multi‐Level Microchannels in Silicon

Method for Fabricating Micro/Nanostructures Via Scanning Probe Microscope and Anisotropic Wet Etching

Design and fabrication of a nanofluidic channel by selective thermal oxidation and etching back of silicon dioxide made on a silicon substrate

Flow-restricted Etching Method on Isotropic Substrates and Its Mechanism

Fabrication of 2D silicon nano-mold by side etch lift-off method

Simple Method for Fabrication of Microchannels in Silicon Carbide

Versatile Approach of Silicon Nanofabrication without Resists: Helium Ion-Bombardment Enhanced Etching

Silicon microstructure processing method based on femtosecond laser treatment and wet etching

A New Silicon Mold Process for Polydimethylsiloxane Microchannels

A Two-Step Etching Method to Fabricate Nanopores in Silicon

Fabrication Of Microfluidic Devices In Silica Glass By Water-Assisted Ablation With Femtosecond Laser Pulses

Integrated fabrication of micro/nano-fluidic chip based on nano-imprint lithography and bonding

Wafer-scale Fabrication of High-Aspect Ratio Nanochannels Based on Edge-Lithography Technique.

Fabrication of Micro-Hole Arrays in Silicon Using Femtosecond Laser Irradiation and Acid Etching

Fabrication of High-Aspect-ratio Grooves in Silicon Using Femtosecond Laser Irradiation and Oxygen-Dependent Acid Etching.

Direct Fabrication of Homogeneous Microfluidic Channels Embedded in Fused Silica Using a Femtosecond Laser

Fabrication of Microchannels on Silica Glass by Femtosecond Laser Multi-Scan： from Surface Generation Mechanism to Morphology Control