Abstract:This paper establishes a transient equivalent circuit of cross‐line same‐phase successive grounding faults, and analyses the characteristics of zero‐sequence current. Then, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed. Finally, a method for faulty line detection based on cross‐correlation distance and transient energy is proposed and different fault conditions verify the effectiveness of proposed method. Currently, theoretical analysis of single‐phase grounding (SPG) faults in low‐current grounding systems has reached a high level of refinement, and the corresponding detection methods have matured. However, there is a significant lack of research on successive grounding (SG) faults, particularly in the area of detecting cross‐line same‐phase successive grounding (CSSG) faults in arc suppression coil grounding systems. To address these issues, a novel faulty line detection method based on transient characteristics of CSSG is proposed. Firstly, a transient equivalent circuit is established, and the characteristics of transient zero‐sequence current (ZSC) are theoretically analysed. Secondly, variational mode decomposition (VMD) is employed to extract low and high‐frequency information from intrinsic mode functions (IMFs). Subsequently, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed, which can accurately detect the occurrence time of secondary faults. Finally, a method for faulty line detection based on cross‐correlation distance (CCD) and transient energy (TE) is proposed. The results of PSCAD simulation under different conditions and field test affirm the accuracy of the analysis and the effectiveness of the proposed method.

Application of Characteristic Components of Transient Signal in Grounded Wire Detection of Ineffectively Earthed Distribution Systems

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Hilbert-Transform-Based Transient/Intermittent Earth Fault Detection in Noneffectively Grounded Distribution Systems

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Faulty line detection for cross‐line same‐phase successive ground faults in distribution network based on transient characteristics

Single-phase fault detection based on the wavelet packet analysis of zero-sequence power components in the Petersen-coil grounded system

Directional Fault Detection Based on Active Power Coefficient in Resonant-Earthed Distribution System

Experimental Research on Typical Single-Phase High Resistance Grounding Fault Detection Methods in Resonant Grounding Distribution System

Earth Fault Detection Method in Non-solidly Earthed Network Based on the Increments of Phase Current

Arc High Impedance Grounding Fault Detection for Resonant Grounding Distribution System Based on Directed Area in Characteristic Frequency Band

Faulty Feeder Detection for Single-Phase-to-Ground Fault in Distribution Networks Based on Transient Energy and Cosine Similarity

Faulty Feeder Detection Based on Fundamental Component Shift and Multiple-Transient-Feature Fusion in Distribution Networks

Analysis and Detection of High Impedance Grounding Fault in Neutral Point Effectively Grounding Distribution Network

Synchronous Measurement Based Transient High Resistance Earth Fault Location in Resonant Grounding System

Faulted feeder identification and location for a single line-to-ground fault in ungrounded distribution system based on principal frequency component

Fault line selection based on current traveling waves and wavelet transform for non-solid-grounded system

Application of EMD and Duffing Oscillator to Fault Line Detection in Un-effectively Grounded System

High-Resistance Grounding Fault Detection and Line Selection in Resonant Grounding Distribution Network

Single phase to ground arcing fault identification based on wavelet packet energy

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

A Method of Single Phase to Ground Fault Feeder Selection Based on Single Phase Current Traveling Wave for Distribution Lines