Abstract:This paper theoretically analyzes the frequency spectrum characteristics of the single-phase ground fault in a Petersen-coil grounded distribution network. Different equivalent circuits are analyzed for faults with low transition resistances and with high transition resistances, separately. The analysis concludes that the system makes a transition from an under-damped state to a damping state, and finally to another under-damped state with the increase of transition resistances. A distribution network model is built with PSCAD/EMTDC. Simulations are performed for different fault locations, different fault initial angles, different transition resistances and different cable proportions. The analysis in time domain and frequency domain is performed. Results show that the use of cables enables the main frequency of the fault current move towards lower frequency. Meanwhile, the amplitude of the fault current obviously increases due to the high capacitance to ground of cables. The transition resistance makes the biggest influence on the characteristic frequency band. Fault location mainly affects the zero sequence current main frequency amplitude. The further the fault location is away from the Bus, the little the amplitude of high-frequency component is. The transient capacitive current component increases, the transient inductive current component decreases and the high-frequency component amplitude increases with the increase of fault initial angles.

Single-phase fault detection based on the wavelet packet analysis of zero-sequence power components in the Petersen-coil grounded system

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Power System Fault Detection Based on Stationary Wavelet Packet Transform and Hilbert Transform

An Adaptive Technique of Earth Fault Detection and Self-Extinguishing by Controllable Petersen-Coil

Single-phase ground fault detection of small current grounding system base on wavelets analysis

A new detection way for single- phase to ground fault based on energy function intergral and wavelet packets

Identification of Series Resonant and Grounding Fault Based on Process Analysis of Zero Sequence Voltage in the Compensation Network

Detecting Single-Phase-to-ground Faulted Feeder in Resonant Grounded Power Distribution System

Discrete Wavelet Transform-Based Triggering Method for Single-Phase Earth Fault in Power Distribution Systems

Single phase to ground arcing fault identification based on wavelet packet energy

Research on Fault Line Selection of Single-Phase Earth Fault Through Extinction Coil

Faulty Line Detection Based on Wavelet Packet Analysis for Distribution Network

Frequency Spectrum Characteristic Analysis of Single-Phase Ground Fault in a Petersen-coil Grounded System

A Single-Phase-to-Ground Fault Detection Method Based on the Ratio Fluctuation Coefficient of the Zero-Sequence Current and Voltage Differential in a Distribution Network

New Approach to Select the Fault Line Based on Transient Energy Features of Fault Phase

Single-phase Grounding Fault Detection Method in Resonant Grounding System Based on Phase Current Variation

Single-phase Grounding Protection Based on Transient Component Analysis

A data-driven method to detect and localize the single-phase grounding fault in distribution network based on synchronized phasor measurement

A NEW APPROACH ON DETECTING THE SINGLE-TO GROUND FAULT LOCATION ON POWER SYSTEM WITH NEUTRAL UNEARTHED

NEW METHOD BASED ON WAVEFORM ANALYSIS TO DETECT EARTH FAULT IN DC SYSTEMS