Abstract:The problem of high impedance fault (HIF) detection in resonant grounding distribution systems has not been well solved. In practical applications, the existing detection methods either have complex calculation processes and low accuracy or have a weak ability to adapt to complex fault conditions, which limits the adaptability of the existing methods. Based on a theoretical analysis, a novel faulty feeder detection method based on the inner product transformation of extreme values is proposed in this paper. First, to eliminate the interference of high-frequency components, the low-frequency characteristic modes of zero-sequence current of each feeder are extracted by the variational mode decomposition (VMD) algorithm. On this basis, the low-frequency intrinsic mode functions (IMFs) are processed by the first-order difference to obtain the current waveform after the difference. Second, the zero crossing point of the differential current waveform is obtained, and then the extreme value point of the original zero-sequence current is calibrated, including the maximum and minimum. Third, at the extreme value point, the comprehensive inner product values (CIPV) of each feeder are calculated. Then, when the values are positive, it is judged as a bus fault, when the value has at least one negative value, it is judged as a feeder fault, and the feeder with the minimum value is judged as a faulty feeder. A large number of simulations and field tests show that this method has better fault detection accuracy in practical applications and is suitable for strong noise interference and asynchronous sampling.

Single Phase Ferroresonance Detection and Type Recognition in Solidly Grounded Power Grid

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Study on simulation of ferroresonance elimination in 10kV power system

A novel ferroresonance and single-phase earth fault recognition method based on correlation analysis

Analytical solution of serial ferroresonance triggered by circuit breaker operation in solidly grounded power grids

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Single-phase Grounding Fault Detection Method in Resonant Grounding System Based on Phase Current Variation

Single-phase fault detection based on the wavelet packet analysis of zero-sequence power components in the Petersen-coil grounded system

A novel detector of ground fault and ferro_resonance in ungrounded distribution system

High-Resistance Grounding Fault Detection and Line Selection in Resonant Grounding Distribution Network

A novel ferroresonance recognition method based on the excitation characteristic of potential transformer

Shunt Petersen-Coil with Resistor for Single Phase Fault Detection in Resonant Grounded Power Distribution Systems

Classification Of Fundamental Ferroresonance, Single Phase-To-Ground And Wire Breakage Over-Voltages In Isolated Neutral Networks

Nonlinear Dynamic Analysis of the Measured Ferroresonance Time Series

Application of wavelet transform to detection of ferro-resonance

Faulty Feeder Detection Under High Impedance Faults for Resonant Grounding Distribution Systems

Theoretical Analysis and Experimental Verification of Fundamental Frequency Ferroresonance

Faulty Feeder Detection Method Based on VMD–FFT and Pearson Correlation Coefficient of Non-Power Frequency Component in Resonant Grounded Systems

Nonlinearity Characteristic of High Impedance Fault at Resonant Distribution Networks: Theoretical Basis to Identify the Faulty Feeder

Detection and Feeder Identification of the High Impedance Fault at Distribution Networks Based on Synchronous Waveform Distortions

Experimental Research on Typical Single-Phase High Resistance Grounding Fault Detection Methods in Resonant Grounding Distribution System