Abstract:A detailed knowledge of structural evolution during mechanical alloying (MA) is of interest and critical for understanding of synthesis mechanism, optimization of milling process, and control of milling products. The structural evolution of the 2Si-BN-3C mixture with a molar ratio of Si:BN:C = 2:1:3 during MA was studied by investigating the changes of phases, morphologies, elemental distributions, microstructures, and chemical bond states using XRD, SEM-EDS, TEM, XPS, and Raman. With the increases in milling time, the particle sizes of the milled 2Si-BN-3C powders first decrease to submicrometers (similar to 1 hour), slightly increase afterward (similar to 3 hours), and eventually decrease to nanoscales gradually reaching equilibrium (>= 10 hours). Depending on the intrinsic crystal structures of themselves, h-BN and graphite are almost amorphized after milling of 10 hours, while amorphization of c-Si takes at least 20 hours. The same milling parameters can provide amorphous Si2BC3N powders, but incompletely amorphous (partially crystalline) SiC powders, which is mainly due to the dilution effect of B and N atoms on the atomic concentration of Si and C hindering the microdiffusion and subsequent mechanochemical reaction of Si and C. Crystallite refinement-induced amorphization is the major synthesis mechanism of amorphous Si2BC3N powders. This work would offer more insight into the MA synthesis of multiple component materials, especially Si-based brittle systems.

Direct Synthesis of MgCNi3 by Mechanical Alloying

Formation of MgCNi3 and Mg–Ni Amorphous Mixture by Mechanical Alloying of Mg–Ni–C System

A New Phase MgNi 3 Synthesized by Mechanical Alloying.

Synthesis and magnetic properties of Ni3Fe intermetallic compound obtained by mechanical alloying

A Study on the Electronic Structure, Superconductivity, and Optical Properties of Mgcni3

An electrochemical investigation of mechanical alloying of MgNi-based hydrogen storage alloys

Preparation of Nb 3 Al Superconductor by Powder Metallurgy and Effect of Mechanical Alloying on the Phase Formation

Synthesis of NiAl(Cr,Nb) Powder by Mechanical Alloying

ChemInform Abstract: A New Phase MgNi3 Synthesized by Mechanical Alloying.

First-principles study on the electronic structure and optical properties of MgCNi3

On the Preparation of Amorphous Mg–Ni Alloys by Mechanical Alloying

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

Preparation of ti-al based nanophase composite powder by mechanical alloying

Solid state reaction and formation of nano-phase composite hydrogen storage alloy by mechanical alloying of MmNi 3.5 (CoMnAl) 1.5 and Mg

Microstructure and formation mechanism of Ni-Al intermetallic compounds fabricated by reaction synthesis

Nanocrystalline Ni-30wt%Fe Supersaturated Solid Solution Synthesized by Mechanical Alloying

Synthesis Mechanism of Amorphous Si2BC3N Powders: Structural Evolution of 2si‐bn‐3c Mixtures During Mechanical Alloying

Induced Effects By The Substitution Of Mg In Mgcni3

Microstructure and Mechanical Properties of Mg-4.0zn Alloy Reinforced by Nio-Coated Cnts

Mechanical Alloying and Spark Plasma Sintering of Ni-Al-Ti-B Powders for Fabricating Nanocrystailine (Tib+tib2)/ni-3(Al, Ti) Composite

Synthesis of Ti3SiC2 Powder by Mechanical Alloying and Mechanical Property of the Sintered Compacts.