Abstract:Accurate fault location reduces operating cost and outage time. This paper proposes a time-domain method to accurately locate faults in transmission lines, which only requires a very short data window (several milli-seconds) during faults. First, the voltage distribution through the line during faults is accurately obtained by solving the matrix form partial differential equations using the proposed numerical scheme. The proposed numerical scheme is mathematically validated for the transmission line fault location problem, with the optimal selection of time and distance intervals to ensure stability and minimum solution error. Afterwards, the fault location is obtained via the extremum value of the voltage distribution. The method fully considers distributed parameters as well as asymmetry of the line. Extensive numerical experiments validated that (a) the proposed numerical scheme demonstrates advantages towards other numerical schemes; (b) the proposed method presents higher fault location accuracy compared to the existing method, independent of fault types, locations and impedances; and (c) the fault location accuracy is not sensitive towards fault inception angles, loading conditions, measurement errors and parameter errors. The proposed method works with relatively low sampling rates (80 samples per cycle) and is compatible with IEC 61850 standard in present digital substations.

Permanent Fault Identification and Location Scheme for MTDC Grid Based on Equivalent Impedance Phase Characteristics and Distributed Parameter Line

Fault Properties Identification Scheme for Hybrid MTDC System Based on LCC Signal Injection and Distributed Parameter Line Model

Identification of Permanent Fault at Transmission Lines with Shunt Reactors Based on Waveform Correlation

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

Novel Fault Location in MTDC Grids With Non-Homogeneous Transmission Lines Utilizing Distributed Current Sensing Technology

Permanent fault identification method based on parameter identification for photovoltaic access to distribution network

An Active Pole-to-ground Fault Location Scheme for FB-MMC-MTDC System Using the Short-Time Blocking of Sub-Modules

Single-end Fault Identification Scheme for Multi-Terminal DC Grid Based on Amplitude Similarity of Injection Signal

Fault Location Method for MMC-HVDC Systems Based on Numerical Laplace Transform

Fault Location Method for Distribution Network Based on Synchronous Measurement

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

Fault Identification Scheme for Protection and Adaptive Reclosing in a Hybrid Multi-Terminal HVDC System

A Permanent Fault Identification Method for Distribution Networks Based on Sequential Reclosing

Time-Domain Transmission Line Fault Location Method With Full Consideration of Distributed Parameters and Line Asymmetry

Permanent Faults Identification Method for Three-phase Autoreclosing Based on Capacitance Parameter

A Single-Ended Fault Location Method for DC Line Based on Active Signal

Fault Property Discrimination Scheme in Hybrid MTDC Power System Based on the Amplitude Distribution of Injection Signal

Fault Location Method for MMC Multi-terminal DC Distribution Network Using Transient DC Currents

Fault Distance Estimation-Based Protection Scheme for DC Microgrids

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

A Method of Single Phase to Ground Fault Feeder Selection Based on Single Phase Current Traveling Wave for Distribution Lines