Abstract:A fault section location method for active distribution network based on characteristic wave coupling is proposed to expand the fault difference. This method explores the principles of characteristic wave coupling, discusses characteristic wave parameter selection theory, examines the start‐up control strategy for characteristic wave coupling, and establishes a protection action criterion by comparing the energy difference of characteristic waves based on the fault identification principle. As distributed generators (DG) and power electronic devices become more integrated, distribution networks have evolved from being passive to active, and power flow has shifted from unidirectional to bidirectional. This transformation has negatively impacted power quality, leading to weakened fault transient attributes and increased harmonic complexities. Consequently, the efficacy of traditional relay protection has diminished, elevating the risk of misoperation or misjudgment and compromising the safety of distribution networks. In response to these challenges, a fault section location method for active distribution network based on characteristic wave coupling is proposed to expand the fault difference. This method explores the principles of characteristic wave coupling, discusses characteristic wave parameter selection theory, examines the start‐up control strategy for characteristic wave coupling, and establishes a protection action criterion by comparing the energy difference of characteristic waves based on the fault identification principle. Subsequently, by utilizing multiple inverter interfaced distributed generators to actively couple characteristic waves into the distribution network during faults, achieves rapid identification and location of fault sections. Finally, the effectiveness of the method is substantiated through simulation results in MATLAB/Simulink and experimental outcomes obtained from a low‐voltage active distribution network experimental platform based on dSPACE1103.

Time-Domain Fault Detection and Location Scheme for Flexible DC Distribution Networks

Research on a Line Protection Method for DC Distribution System Based on Parameter Identification

An Integral Fault Location Algorithm Based on a Modified T-Source Circuit Breaker for Flexible DC Distribution Networks

Single-end Fault Location Technique for DC Distribution Lines Based on Network Topology and Measured Traveling Waves

Time-Domain Transmission Line Fault Location Method With Full Consideration of Distributed Parameters and Line Asymmetry

Fast Fault Detection and Location of DC Distribution Grid Based on Ultra-Highspeed Travelling Wave

Fault Characteristic Analysis and a Novel Pilot Protection Scheme for Pole-to-Ground Fault in Flexible DC Distribution Network

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

Faulty feeder detection based on the fluctuation characteristics of inflection point dense area for DC distribution network

A Novel Fault Let-Through Energy Based Fault Location for LVDC Distribution Networks

Fault location based on variable mode decomposition and kurtosis calibration in distribution networks

Fault Location Method for Distribution Network Based on Synchronous Measurement

Fault Location Method for Distribution Network Using an Additional Inductance Strategy

Active distribution network fault section location method based on characteristic wave coupling

Active Fault-Locating Scheme for Hybrid Distribution Line Based on Mutation of Aerial-Mode Injected Pulse

Protection and Fault Isolation Scheme for DC Distribution Network Based on Active Current-Limiting Control

A Single-Ended Protection for Multi-terminal Flexible DC Distribution System

Fault Location Method in Power Network by Applying Accurate Information of Arrival Time Differences of Modal Traveling Waves

Enhancing Resilience and Reliability of Active Distribution Networks through Accurate Fault Location and Novel Pilot Protection Method

Fault location method for multi-terminal MMC-based MVDC distribution system under DC pole-to-ground fault

Fault detection method for flexible DC grid based on current limiting reactance voltage variability