Abstract:Abstract The feasible resolution of angular displacement measurement by an optical angle sensor based on laser autocollimation is investigated. Improving the sensor sensitivity while maintaining the noise level of the sensor signal as low as possible is necessary to achieve high-resolution angular displacement measurement. In this paper, the contribution of each component, such as a photodiode, a trans-impedance amplifier, and an analog-to-digital converter in the optical angle sensor, to the noise level of the sensor signal is first estimated on the basis of theoretical equations. The feasible sensitivity of the optical angle sensor is also estimated in numerical calculations. The sensitivity of a photodiode element at the edge of its photosensitive area is evaluated in experiments to realize the estimation of the angle sensor sensitivity. Experimental results are applied to the numerical calculations. The influences of the measurement laser beam diameter, the spot diameter of the focused laser beam on the photosensitive area, and the focal length of the collimator objective of the optical angle sensor are also considered in the numerical calculations. Finally, a prototype optical setup is developed. Experiments are performed to demonstrate that a compact optical angle sensor based on laser autocollimation with a collimator objective having a focal length shorter than 100 mm can achieve a resolution beyond 0.001 arc-second with a bandwidth of 1 kHz. This resolution is better than those achieved by commercial autocollimators employing an image sensor or a position-sensitive detector. The industrial contribution of this paper lies in the detailed breakdown of noise components in the readout signal of an angle sensor in a practical condition and the systematic estimation of its feasible resolution as well as its sensitivity.

High-precision autocollimation method based on a multiscale convolution neural network for angle measurement

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Small Angular Displacement Measurement Based on an Autocollimator and a Common-Path Compensation Principle.

Ultra-sensitive angle sensor based on laser autocollimation for measurement of stage tilt motions

Optical Frequency Domain Angle Measurement in a Femtosecond Laser Autocollimator.

Laser autocollimation based on an optical frequency comb for absolute angular position measurement

Aberration Correction Method For Fourier Ptychographic Microscopy Based On Neural Network

A Three-Dimensional Small Angle Measurement System Based on Autocollimation Method.

Precision Roll Angle Measurement System Basedon Autocollimation

Precise and Robust Binocular Camera Calibration Based on Multiple Constraints

Research on the Influence Model of Collimating Lens Aberrations in Autocollimation System Based on the Ray-Tracing Method

2D Micro-Angle Sensor Based on Laser Autocollimation

Autocollimation With Ultra-High Resolution And Stability Using Telephoto Objective Together With Optical Enlargement And Beam Drift Compensation

Three-degree-of-freedom autocollimation angle measurement method based on crosshair displacement and rotation.

Two-dimension automatic tracking vision autocollimator system

An Autocollimator Axial Measurement Method Based on the Strapdown Inertial Navigation System

Distortion spot correction and center location base on deep neural network and MBAS in measuring large curvature aspheric optical element

Feasible Resolution of Angular Displacement Measurement by an Optical Angle Sensor Based on Laser Autocollimation

Large-Dynamic-Range Ocular Aberration Measurement Based on Deep Learning with a Shack–Hartmann Wavefront Sensor

Three-degree-of-freedom autocollimator with large angle-measurement range

Further Improvement of Edge Location Accuracy of Charge-Coupled-Device Laser Autocollimators Using Orthogonal Fourier-Mellin Moments