Abstract:Autocollimators are widely used optical axis-measuring tools, but their measurement errors increase significantly when measuring under non-leveled conditions and they have a limited measurement range due to the limitations of the measurement principle. To realize axis measurement under non-leveled conditions, this paper proposes an autocollimator axis measurement method based on the strapdown inertial navigation system (SINS). First, the measurement model of the system was established. This model applies the SINS to measure the change in attitude of the autocollimator. The autocollimator was then applied to measure the angular relationship between the measured axis and its own axis, based on which the angular relationship of the axis was measured via computation through signal processing and data fusion in a multi-sensor system. After analyzing the measurement errors of the system model, the Monte Carlo method was applied to carry out a simulation analysis. This showed that the majority of the measurement errors were within ±0.002° and the overall measurement accuracy was within ±0.006°. Tests using equipment with the same parameters as those used in the simulation analysis showed that the majority of the measurement errors were within ±0.004° and the overall error was within ±0.006°, which is consistent with the simulation results. This analysis proves that this method solves the problem of the autocollimator being unable to measure the axis under non-leveled conditions and meets the needs of axis measurement with the application of autocollimators under a moving base.

Research on the Influence Model of Collimating Lens Aberrations in Autocollimation System Based on the Ray-Tracing Method

Small Angular Displacement Measurement Based on an Autocollimator and a Common-Path Compensation Principle.

A Systemic Model for Simultaneously Measuring Three dimensional Rotation Angles of the Linear Guide Track [J]

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Rigid Geometric-Optics Autocollimation Model and Its Theoretical Analysis Based on Ray-Tracing Method

Spherical Aberration Compensation Method for Long Focal-Length Measurement Based on Talbot Interferometry

Calibration for the Errors Resulted from Aberration in Long Focal Length Measurement

Laser autocollimation based on an optical frequency comb for absolute angular position measurement

A MEASUREMENT AND ANALYTICAL METHOD FOR THE EFFECTS OF OBJECTIVE LENS ABERRATION ON ITS RESOLUTION

Research of the Influence of Rectangular Prism Pien Error on Angle Measurement for Photoelectric Autocollimator

Practical and Accurate Method for Aspheric Misalignment Aberrations Calibration in Non-Null Interferometric Testing

High-precision autocollimation method based on a multiscale convolution neural network for angle measurement

The shift–rotation absolute testing method based on autocollimation

A Three-Dimensional Small Angle Measurement System Based on Autocollimation Method.

Theoretical Analysis of Collimators on the Geometrical Calibration of Wide Field-of-view Radiometer

Effects of incident beam deviation from the center of a cat's eye retro-reflector on the measurement accuracy of a laser tracing system

An Autocollimator Axial Measurement Method Based on the Strapdown Inertial Navigation System

Influence of Tilt on Collinear Calibration of a Laser Interferometer

Characterized environmental influences on autocollimator measurement uncertainty using an extended Allan variance

Influences of fluorescence film thickness and optical aberrations on curved surface metrology in fluorophore-aided scattering confocal microscopy

Correction of the error induced by obscurations of Ritchey-Chretien collimators for high-resolution space camera MTF measured with the ISO 12233 slanted-edge method