Abstract:Along with the rapid development of aerospace, automobile, die & mold industries, free-form surface products are widely used, and the measurement and reverse engineering of freeform surface products become research focus. Free-form surface products include many kinds of curve patches (flat, column surface, spherical surface, irregular surfaces, etc). The key in reverse engineering of free-form surface products is numerical measurement. Between the product surfaces and measuring platform is the skip edge, and C0&C1 continual edges are between the patches. Measuring by different areas compartmentalized according to the edges is a good method, which expedites the measurement and modeling. Even in whole measurement, the ship edge and C0&C1 continual edge are also important in surface modeling. In recent years, CCD camera or data point segmentation from massive data point clouds is often applied in edge detection research. But some negative factors still exist when using the CCD to integrate CNC machine such as difficult assembly, complicated system demarcation and high cost and so on. The disadvantages of using data point segmentation are low precision, lots of useless data points and measurement time, reduce the efficiency. In order to overcome the disadvantages, this article aims at laser non-contact measurement, an edge measuring method of free-form surface which is based of sampling is put forward. And it provides an idiographic way for the skip edge or C0&C1 continual edge which are widely uses in free surface parts. Because the edge detection method can make out measurement path according to the edge curve and optimize measurement points, the laser probe can adaptively measure the parts in a fast and accurate mode. Finally experiments show that the method is effective. And this method can be used to regulation part measurement too.

Further Improvement of Edge Location Accuracy of Charge-Coupled-Device Laser Autocollimators Using Orthogonal Fourier-Mellin Moments

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

A lateral differential confocal microscopy for accurate detection and localization of edge contours

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Small Angular Displacement Measurement Based on an Autocollimator and a Common-Path Compensation Principle.

Laser autocollimation based on an optical frequency comb for absolute angular position measurement

Fast and Precise Center Location for Circle Target of CCD Laser Autocollimator

Optical Frequency Domain Angle Measurement in a Femtosecond Laser Autocollimator.

Study on Edge Detection Based on Sampling in CNC Non-Contact Measuring System

Further Improvement of Edge Location Accuracy of Double Fiber Spherical Coupling Sensor Using Orthogonal Jacobi–Fourier Moments

Subpixel Edge Location Based on Orthogonal Fourier-Mellin Moments.

2D Micro-Angle Sensor Based on Laser Autocollimation

High-precision Small-angle Measurement of Laser-fiber Autocollimation Using Common-path Polarized-light Difference

Two-dimension automatic tracking vision autocollimator system

High-precision Radius Automatic Measurement Using Laser Differential Confocal Technology

Subpixel Edge Location Method Proposed to Improve the Performance of Optical Fiber Spherical Coupling Probe During Dimensional Measurement of Micro-Cavities with High Aspect Ratio

Efficient Positional Misalignment Correction Method for Fourier Ptychographic Microscopy.

Edge-based near-field photolithography optical proximity effect correction technique

Recent Advances In Our Research On Ultrahigh Resolution Laser Confocal Microscopy

An Algorithm for Circular Test and Improved Optical Configuration by Two-Dimensional (2D) Laser Heterodyne Interferometer.