Abstract:W/CuCrZr alloy composite panels are promising plasma-facing components for use in future nuclear-fusion reactors. However, the intrinsic immiscibility of W and Cu makes joining them difficult. In this study, we developed a vacuum diffusion bonding method that involves sandblasting of the W substrate surface, Cu electroplating and annealing, and subsequent vacuum diffusion bonding to realize W/CuCrZr joints with high bond strength. The morphologies and structures of the W and W/CuCrZr joints were investigated by scanning electron microscopy, X-ray diffraction, and high-resolution transmission electron microscopy. Sandblasting was found to induce the plastic deformation, roughening, and grain refinement of the W substrate surface. During Cu plating on the surface of the sandblasted W (and subsequent annealing), the Cu layer was embedded in micron-scale irregular pits on the sandblasted W surface, creating a tight bond. The shear bond strength (184 MPa) and bonding quality of a W/CuCrZr joint obtained with the sandblasting/Cu interlayer method was superior to those of a W/CuCrZr joint prepared by conventional vacuum diffusion bonding. The structural origins of this superior W/CuCrZr joint were related to a region of W and Cu interdiffusion with a thickness of approximately 30 nm. This improved vacuum diffusion bonding method for W and CuCrZr can facilitate the development of plasma-facing components for future nuclear-fusion devices. (c) 2021 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).

Performance of fine-grained W/Cu plate prepared by explosive welding with high wave impedance confinement at room temperature

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Microstructure and Corrosion Behaviour of WC-Co Coating Fabricated by Plasma Arc Welding

Thermal Shock Performance of CVD Tungsten Coating at Elevated Temperatures

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Investigation on the interfacial microstructure and mechanical properties of the W-Cu joints fabricated by hot explosive welding

Interfacial evolution mechanism of W/Cu explosive welding interface affected by preheating

Enhanced Tensile Ductility of Tungsten Microwires Via High-Density Dislocations and Reduced Grain Boundaries

Microstructure and mechanical properties investigation of explosively welded titanium/copper/steel trimetallic plate

Electroless Copper Plating of Tungsten Powders and Preparation of WCu20 Composites by Microwave Sintering

Design and Thermal Shock Performance of W/Cu Functionally Graded Material used as Plasma Facing Component

High-temperature mechanical and electrical properties of W-particle-reinforced Cu-matrix composites from improved electroless plated powders

Engineering performance of tungsten network reinforced copper matrix composites synthesized by selective laser melting and infiltration

Insight into the Microstructure and Tensile Behavior of the W–Cu Composite Reinforced with Tungsten Fibers and Particulates

Freeze-casted tungsten skeleton reinforced copper matrix composites

Interfacial Microstructure and Shear Behavior of the Copper/Q235 Steel/Copper Block Fabricated by Explosive Welding

Preparation of Tungsten Fiber Reinforced-Tungsten/copper Composite for Plasma Facing Component

Microstructure and high-temperature mechanical properties of Cu-W composite prepared by hot isostatic pressing

High-strength Vacuum Diffusion Bonding of Cu-plated, Sandblasted W and CuCrZr Alloy

The effects of ultrasonic vibration on mechanical properties of tungsten particle-reinforced copper-matrix composites

Mechanical Properties of a Novel Tungsten Fiber-Reinforced Tungsten Composite Prepared Through Powder Extrusion Printing and High-Pressure High-Temperature Sintering