Abstract:Much of the recent ongoing advanced research into the quest for improved etching techniques has brought forth a broad concept for the fabrication of micro/nano-electromechanical systems (MEMS/NEMS) having high accuracy, precision, efficiency, compatibility and through-put of metallic- as well as carbon-composition structural phases. This in turn leads towards a thorough understanding of the sensing, trapping, separating, controlling, positioning, directing, concentrating and manipulating of micro-nano-sized particles - predominantly biological particles - in the emerging MEMS/NEMS technological field. This paper focuses its attention on the easiest means of wet-etching {100}-type silicon wafer surfaces by guiding the choice of [<100> or <010>] orientation (at 45° to the normal orientation). This anisotropic etching is performed in KOH solution. Here, consideration is not concerned to a large extent with process parameters as in anodic oxidation, an intensely doped boron etching stops and silicon wafer surface back-etching. The main concern of the present practical application route involves a passivating material (silicon dioxide, SiO2) and two masking stages (for a two-step etching process). As a example of this method, silicon cantilever beams having vertical edges are produced. It is concluded that the method presented will be helpful in the comprehensive study of resonators, pressure/temperature sensors, three-dimensional carbon micro-electrodes, actuators and accelerometers for bioparticle applications.

Optimization of Thin Metal Layer Etch Process for MEMS/Sensor Application*

Optimization Of Thin Metal Layer Etch Process For Hems/Sensor Application

Design, Fabrication And Measurement Of Tan Thin Film Resistor Based On Mems Technology

Design and Application of a Metal Wet-Etching Post-Process for the Improvement of CMOS-MEMS Capacitive Sensors

One-step Silicon Substrate Through-Wafer Etching Process for High Precision MEMS Application

Post-Cmos Selective Electroplating Technique for the Improvement of Cmos-Mems Accelerometers

An improved tungsten titanium film photolithography process with single photoresist shaping mask

Effective Approaches to Improve Au Etching Process Performance in MEMS Devices

Patterning of nickel-titanium SMA films with chemical etching by a novel multicomponent etchant

Optimization of the GaAs-on-Si Substrate for Microelectromechanical Systems (MEMS) Sensor Application

A Novel Wet Etching Process of Pb(Zr,Ti)O-3 Thin Films for Applications in Microelectromechanical System

A Two-step Wet Etching Process of PZT Thin Film With Ultra-low Undercut for MEMS Applications

Design and Implementation of Multi-Layer Opened-IDAs Electrodes for the Response Enhancement of CMOS-MEMS Gas Sensors at Room Temperature

Process Development for CMOS-MEMS Sensors with Robust Electrically Isolated Bulk Silicon Microstructures

Investigation of Tan As the Wet Etch Stop Layer for Hkmg-Last Integration in the 22 Nm and Beyond Nodes Cmos Technology

A Boost-Up Method of Mems-Bulk-Micromachining Towards C-Mems Fabrication for Sensing and Manipulating Bioparticles

Optimization of Wet strip after Metal Hard Mask All-in-One Etch for metal void reduction and yield improvement

Fabricating Processes of Free-Standing Silicon Nitride Thin Film for MEMS Devices

Application of KOH Anisotropic Etching in the Fabrication of MEMS Devices

Oxide Or Metal Interface Damage Improvement Of Deep Silicon Etch Process By Low Power Rf Of Low Frequency

&Lt;title>patterning of Nickel-Titanium SMA Films with Chemical Etching by a Novel Multicomponent Etchant</title>