Abstract:This work presents our recent research and development of environment-friendly MEMS fabrication technology based on an eco-friendly silicon deep reactive ion etching (D-RIE), and polymer-MEMS utilizing hot embossing process. In order to show the capability of this ‘Green’ fabrication technology, several typical MEMS devices have been fabricated successfully. Regarding silicon dry etching technology, the often-used gas SF6 which has very high Global Warming Potentials (GWP) should be replaced by other lower GWP gases, such as Ar/F2. First, the gases were selected with consideration of the simple handle and less danger. Then, Si etching experiments corresponding to these gases were performed and analyzed systematically to find out the most suitable process which can reduce or replace SF6 gas. Furthermore, the etching rate improvement was also studied based on process’s real-time monitoring and feed-back control technology to optimize the timing of deposition and etching steps (Bosch process); therefore, bias RF power can be smartly controlled during the process. In polymer-MEMS technology, we have developed a novel fabrication of a monolithic PMMA MEMS devices utilizing hot embossing, surface-activated direct bonding, polishing, and elliptical vibration cutting processes. The robustness and capability of the method are demonstrated through the fabrication of sophisticated PMMA freestanding micro structures and devices. An efficient technique using reinforcement material to protect the PMMA microstructures during release process was proposed. Small Young’s modulus and high thermal expansion of polymer are the advantages for electrostatic and thermal actuators, respectively, because it will require less power than silicon counterparts to produce the same displacement. All PMMA acceleration sensor, actuators and mirror device have been fabricated to shows the advantages of polymer-MEMS technology. Fig. 1 shows typical MEMS devices made of PMMA polymer by using our polymer-MEMS fabrication process.

Fabricating Processes of Free-Standing Silicon Nitride Thin Film for MEMS Devices

Fabricating Processes Of Free-Standing Silicon Nitride Thin Film For Mems Devices

Robust Free‐Standing Nano‐Thin SiC Membranes Enable Direct Photolithography for MEMS Sensing Applications

Fabrication of SiC MEMS Pressure Sensor Based on Novel Vacuum-Sealed Method

Fabrication of SiCN MEMS by UV Lithography of Polysilazane

Fabrication of Si<sub>3</sub>N<sub>4</sub> Micro-Components by a Combined Microfabrication Process

Fabrication of Nanoporous Silicon Dioxide/silicon Nitride Membranes Using Etched Ion Track Technique

Fabrication of Si3N4 micro-components by a combined microfabrication process

RF Reactive Sputtering AlN Thin Film at Room Temperature for CMOS-compatible MEMS Application

A Novel Fabrication Process of MEMS Devices on Polyimide Flexible Substrates

Environment Friendly MEMS Process

Experimental Study on Roughness and Flatness of Micromirror Fabricated by Different Anisotropic Silicon Etching Processes

Optimization of Etching Processes for the Fabrication of Smooth Silicon Carbide Membranes for Applications in Quantum Technology

Fabrication of SiC MEMS Pressure Sensor by Anodic Bonding

Transfer of III-nitride epitaxial layers onto pre-patterned silicon substrates for the simple fabrication of free-standing MEMS

Cryogenic DRIE Processes for High-Precision Silicon Etching in MEMS Applications

Fabrication of SOI MEMS Inertial Sensors with Dry Releasing Process

Synthesis and Characterization of LPCVD Polysilicon and Silicon Nitride Thin Films for MEMS Applications

Fabrication of GaN-based MEMS Structures Using Dry-Etch Technique

Zr/V/Fe Thick Film for Vacuum Packaging of Mems

Photothermally Assisted Thinning of Silicon Nitride Membranes for Ultrathin Asymmetric Nanopores.