Abstract:This work presents our recent research and development of environment-friendly MEMS fabrication technology based on an eco-friendly silicon deep reactive ion etching (D-RIE), and polymer-MEMS utilizing hot embossing process. In order to show the capability of this ‘Green’ fabrication technology, several typical MEMS devices have been fabricated successfully. Regarding silicon dry etching technology, the often-used gas SF6 which has very high Global Warming Potentials (GWP) should be replaced by other lower GWP gases, such as Ar/F2. First, the gases were selected with consideration of the simple handle and less danger. Then, Si etching experiments corresponding to these gases were performed and analyzed systematically to find out the most suitable process which can reduce or replace SF6 gas. Furthermore, the etching rate improvement was also studied based on process’s real-time monitoring and feed-back control technology to optimize the timing of deposition and etching steps (Bosch process); therefore, bias RF power can be smartly controlled during the process. In polymer-MEMS technology, we have developed a novel fabrication of a monolithic PMMA MEMS devices utilizing hot embossing, surface-activated direct bonding, polishing, and elliptical vibration cutting processes. The robustness and capability of the method are demonstrated through the fabrication of sophisticated PMMA freestanding micro structures and devices. An efficient technique using reinforcement material to protect the PMMA microstructures during release process was proposed. Small Young’s modulus and high thermal expansion of polymer are the advantages for electrostatic and thermal actuators, respectively, because it will require less power than silicon counterparts to produce the same displacement. All PMMA acceleration sensor, actuators and mirror device have been fabricated to shows the advantages of polymer-MEMS technology. Fig. 1 shows typical MEMS devices made of PMMA polymer by using our polymer-MEMS fabrication process.

A Novel Fabrication Process of MEMS Devices on Polyimide Flexible Substrates

A cost-effective flexible MEMS technique for temperature sensing

Key Technology of Micromachined Temperature Sensor Arrays on Polyimide Flexible Substrates

A Temperature Sensor Array Based on Flexible MEMS Skin Technology

Low Temperature Photosensitive Polyimide Based Insulating Layer Formation for Microelectromechanical Systems Applications

Design and Fabrication of the Polyimide-Based Flexible MEMS Capacitive Tactile Force Sensor

Environment Friendly MEMS Process

Development of Flexible Nickel Thermal Sensor Array

A hybrid polymer/ceramic/semiconductor fabrication platform for high-sensitivity fluid-compatible MEMS devices with sealed integrated electronics

Flexible Implantable Microtemperature Sensor Fabricated on Polymer Capillary by Programmable UV Lithography with Multilayer Alignment for Biomedical Applications

Microfabrication of Functional Polyimide Films and Microstructures for Flexible MEMS Applications

Parylene-MEMS Technique-Based Flexible Electronics

Flexible Piezo-Mems Fabrication Process Based on Thinned Piezoelectric Thick Film

Fabrication of SiCN MEMS by photopolymerization of pre-ceramic polymer

Low-thermal-budget electrically active thick polysilicon for CMOS-First MEMS-last integration

Fabrication of robust electrothermal MEMS devices using aluminum?tungsten bimorphs and polyimide thermal isolation

Microfabrication of plastic-PDMS microfluidic devices using polyimide release layer and selective adhesive bonding

Fabrication of a Flexible Polyimide-Based Electrostatically Actuated MEMS Relay

Temperature Sensor in a Flexible Substrate

Highly elastic conductive polymeric MEMS

A Novel Micro Heater Integrated On Flexible Polyimide Substrate With Fast Response And Uniform Temperature Distribution