Abstract:Hypothesis: Zirconia microparticles produced by sol-gel synthesis have great potential for photonic applications. To this end, identifying synthetic methods that yield reproducible control over size uniformity is important. Phase transformations during thermal cycling can disintegrate the particles. Therefore, understanding the parameters driving these transformations is essential for enabling high-temperature applications. Particle morphology is expected to influence particle processability and stability. Yttria-doping should improve the thermal stability of the particles, as it does in bulk zirconia. Experiments: Zirconia and YSZ particles were synthesized by improved sol-gel approaches using fatty acid stabilizers. The particles were heated to 1500 °C, and structural and morphological changes were monitored by SEM, ex situ XRD and high-energy in situ XRD. Findings: Zirconia particles (0.4-4.3 μm in diameter, 5-10% standard deviation) synthesized according to the modified sol-gel approaches yielded significantly improved monodispersities. As-synthesized amorphous particles transformed to the tetragonal phase at ∼450 °C with a volume decrease of up to ∼75% and then to monoclinic after heating from ∼650 to 850 °C. Submicron particles disintegrated at ∼850 °C and microparticles at ∼1200 °C due to grain growth. In situ XRD revealed that the transition from the amorphous to tetragonal phase was accompanied by relief in microstrain and the transition from tetragonal to monoclinic was correlated with the tetragonal grain size. Early crystallization and smaller initial grain sizes, which depend on the precursors used for particle synthesis, coincided with higher stability. Yttria-doping reduced grain growth, stabilized the tetragonal phase, and significantly improved the thermal stability of the particles.

PREPARATION OF ZIRCONIA SOL BY ANION EXCHANGE METHOD FROM ZIRCONYL CHLORIDE

Preparation of Zirconia Powders by Sol-gel Process

A General Propylene Epoxide-assisted Sol-Gel Route for the Synthesis of ZrO2-SnO2 Composite Sols

The Preparation,Stability of Zirconium Sol and Characteristics of ZrO_2 Powder

Synthesis, Characterization and Application of Submicron ZrSiO4 Powder Via Sol-Gel-microemulsion-hydrothermal Method

Synthesis of Monolithic Zirconia with Macroporous Bicontinuous Structure Via Epoxide-Driven Sol–gel Process Accompanied by Phase Separation

A Novel Preparation Process for Thermally Stable Ultrafine Tetragonal Zirconia Aerogel

Phase Composition Controllable Preparation of Zirconia Nanocrystals Via Solvothermal Method

PREPARATION AND PROPERTIES OF NANOMETER POLYCRYSTALS ZIRCONIA POWDER BYSUPER ALKALINE METHOD AT LOW TEMPERATURE WITH ORGANIC ADDITIVES

Influences of preparation parameters on the structural and catalytic performance of zirconia in isosynthesis

Preparation and Microstructure of Nanometer Tetragonal Polycrystal Zirconia Powder at Low Temperature Condition

Study on the process and properties of nano-sized polycrystal zirconia powders by co-precipitation in super-alkaline medium

Physical Chemistry of Controlled-Hydrolysis of Propanol Zirconia Doped with Yttrium Nitrite

Sol–gel Synthesis and Electrical Properties of (zro2)0.85(reo1.5)0.15 (RE = Sc, Y) Solid Solutions

Synthesis and thermal stability of zirconia and yttria-stabilized zirconia microspheres

Preparation of macroporous zirconia monoliths from ionic precursors via an epoxide-mediated sol-gel process accompanied by phase separation

Study on a new, environmentally benign method and its feasibility of preparing nanometer zirconia powder

Preparation of amorphous ZrO2 powders by hydrothermal-assisted sol-gel method

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

Amino Acid‐Mediated Formation of Zirconia Nanoparticles and their Transparent Dispersions

Sol-Gel Synthesis of Yttria Stabilized Zirconia Membranes Through Controlled Hydrolysis of Zirconium Alkoxide