Abstract:Hypothesis: Zirconia microparticles produced by sol-gel synthesis have great potential for photonic applications. To this end, identifying synthetic methods that yield reproducible control over size uniformity is important. Phase transformations during thermal cycling can disintegrate the particles. Therefore, understanding the parameters driving these transformations is essential for enabling high-temperature applications. Particle morphology is expected to influence particle processability and stability. Yttria-doping should improve the thermal stability of the particles, as it does in bulk zirconia. Experiments: Zirconia and YSZ particles were synthesized by improved sol-gel approaches using fatty acid stabilizers. The particles were heated to 1500 °C, and structural and morphological changes were monitored by SEM, ex situ XRD and high-energy in situ XRD. Findings: Zirconia particles (0.4-4.3 μm in diameter, 5-10% standard deviation) synthesized according to the modified sol-gel approaches yielded significantly improved monodispersities. As-synthesized amorphous particles transformed to the tetragonal phase at ∼450 °C with a volume decrease of up to ∼75% and then to monoclinic after heating from ∼650 to 850 °C. Submicron particles disintegrated at ∼850 °C and microparticles at ∼1200 °C due to grain growth. In situ XRD revealed that the transition from the amorphous to tetragonal phase was accompanied by relief in microstrain and the transition from tetragonal to monoclinic was correlated with the tetragonal grain size. Early crystallization and smaller initial grain sizes, which depend on the precursors used for particle synthesis, coincided with higher stability. Yttria-doping reduced grain growth, stabilized the tetragonal phase, and significantly improved the thermal stability of the particles.

A Novel Preparation Process for Thermally Stable Ultrafine Tetragonal Zirconia Aerogel

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

Preparation and Heat Treatment of Titania Aerogels by Ambient Pressure Drying

Characterization of High-Surface-Area Zirconia Aerogel Synthesized from Combined Alcohothermal and Supercritical Fluid Drying Techniques

Synthesis, Characterization and Application of Submicron ZrSiO4 Powder Via Sol-Gel-microemulsion-hydrothermal Method

Synthesis of high-temperature resistant monolithic zirconia-based aerogel via facile water glass assisted sol–gel method

Highly thermally stable zirconia/silica composite aerogels prepared by supercritical deposition

A Simple Alcohothermal Synthetic Route to High Surface Area Zirconia Aerogel

Preparation of Alumina Aerogel via Supercritical Method

Preparation and properties of low-density and high-temperature resistant yttrium doped silica aerogels

Preparation of spherical zirconia powder by nano-reactor of microemulsion and its densification behavior

Preparation and Microstructure of Nanometer Tetragonal Polycrystal Zirconia Powder at Low Temperature Condition

Yttria-stabilized zirconia (8YSZ) synthesis in a supercritical CO 2 -assisted process: a parametric study for achieving cubic phase stability

Nano-dispersed yttria-stabilized zirconia powder: Phase, morphology, and conductivity investigation with different chelating agents via a modified sol-gel method

Design and preparation of novel Y2O3-SiO2 composite aerogels for high-temperature thermal insulators

Study on the process and properties of nano-sized polycrystal zirconia powders by co-precipitation in super-alkaline medium

Preparation of spherical zirconia powder in microemulsion system and its densification behavior

One-step Synthesis of Monolithic Micro-Nano Yttria Stabilized ZrO2-Al2O3 Composite Aerogel

Synthesis and thermal stability of zirconia and yttria-stabilized zirconia microspheres

Study on a new, environmentally benign method and its feasibility of preparing nanometer zirconia powder

A Novel Route for the Preparation of Ultrafine Yttria-Doped Zirconia Powders