Abstract:The preparation of monolithic silica aerogels via non-supercritical drying is realized by the following procedures: (1) formation of silica alcogels with perfect network structure by controlling two-step hydrolysis and condensation reaction rates of tetraethoxysilane; (2) improvement and reinforcement of network structure and strength of silica gels through exchanging the pore fluid with ethanol solvent thoroughly, immersing of gels in the ethanol solutions of tetraethyoxysilane and aging; (3) gradual drying under ethanol fluid whose surface tension is much lower than water under ambient pressure. The resulting aerogels were characterized by means of SEM, TEM, TG-DTA, XRD, and adsorption-desorption techniques. It is found that the aerogels, which are made up of uniform spherical nanoparticles with diameters of about 10 nm, are of coherent network structures. Furthermore, the aerogels are porous, and the porosity is as high as 91%. The diameter of the pore sizes is in the range of 10 similar to 30 nm, and the density of the aerogels is low (200 similar to 400 kg . m(-3)). The specific surface area of the aerogels can be as high as 625. 65 m(2) . g(-1). The appearance, microstructure, diameters of primary particles and pore size distributions of the aerogels are in concordance with those prepared by conventional supercritical drying. It is demonstrated that the quality of the resulting aerogels is affected by the preparation conditions adopted in the preparation process. In fact, by adjusting the proportions of the reaction systems, and controlling the adding amounts of acid and base during the two-step hydrolysis and condensation process, silica aerogels with required density, definite strength and ideal morphology can be produced.

Preparation of Alumina Aerogel via Supercritical Method

Preparation and Heat Treatment of Titania Aerogels by Ambient Pressure Drying

PREPARATION OF SILICA AEROGELS BY SUPERCRITICAL DRYING TECHNIQUE

Studies on the preparation of Fe2O3 aerogels through sol-gel process and supercritical drying technique

Preparation of SiO2 aerogels with sol-gel method and the study of their properties

Preparation and characterization of monolithic alumina aerogels

Synthesis and Thermal Behavior of High-Surface-Area Monolithic Alumina Aerogels

Preparation of Fe2O3-SiO2 Aerogels by Supercritical Drying Technique

Preparation of Silica Aerogels by Non-Supercritical Drying

Preparation and Thermal Stablity of Silica- alumina-fibers Composite Aerogels

Preparation And Characterization Of Al2o3 Bulk Aerogel With High Specific Surface Area And Low Density

Preparation and Characterization of Heat-resistant Silica-alumina Composite Aerogel

Preparation of Silica Aerogels Via Non-supercritical Drying and Their Formation Process

Preparation and Thermal Performance of Alumina Aerogel Insulation Composites

Preparation of Heat-Resistant Silica/Alumina Composite Aerogel by Adding Trimethylethoxysilane

Synthesis of Alumina Aerogels by Ambient Drying Method and Control of Their Structures

Synthesis and characterization of SiO2-Al2O3 composite aerogel using inorganic aluminum salt as raw material

Studies on Preparation of Carbon Aerogels

Preparation of Aerogels by Non-supercritical Drying Technique

Study of Phase Transition in SiO2 Aerogel Balls During the Heat Treatment

Preparation and characterization of monolithic TiO2/SiO2 aerogels obtained by non-supercritical drying method