Abstract:Crack-free mesoporous equimolar Al2O3-SiO2-TiO2 ternary nanocomposite aerogel has been synthesized using an ethanol supercritical drying technique. The effects of heat treatment temperatures on its textural and structural evolution during thermal treatment are investigated in this study. XRD results reveal that only anatase phase is detected in the as-dried ternary aerogel, whereas peaks corresponding to silica and alumina phase are not shown due to its much faster polymerization rate of titania precursor. Structural transition from boehmite to γ-Al2O3 begins to occur at 450°C within the ternary aerogel, and this process is completed at nearly 615°C. The needle-like reticulated γ-Al2O3 grows along the anatase backbone, however, it is not evident in the XRD patterns. The morphologies of the ternary aerogel become more homogeneous after the structural transition, as indicated by the SEM analysis, which is also consistent with the BET results. With the increase of heat temperature up to 1050°C, the γ-Al2O3 phase disappears and no separate SiO2 is detected. At the same time, the silica-alumina network originates in a structure of Al-O-Si, and the silicon atoms incorporate into the alumina phase in the γ-Al2O3 structure, disordering the alumina primary particles. When the heat treatment temperature increases to 1200°C, mullitization begins to occur along the titania backbone, whereas silica crystallization happens at 1300°C. The 600°C calcinated ternary aerogel is typically mesoporous, showing high specific surface area (255.37m2/g), suitable average pore diameter (22.83nm) and large pore volume (1.34cm3/g). Moreover, the ternary aerogels show high surface acid activity at temperatures below 1000°C, which have future applications for ideal catalysts and catalyst supports at elevated temperatures.

Fabrication and Thermal Stability of La2O3 Doped Alumina Aerogel

Investigation of the effect of lanthanum oxide on the thermal stability of alumina aerogel

Highly Thermally Stable Alumina-Based Aerogels Modified by Partially Hydrolyzed Aluminum Tri-Sec-butoxide

Preparation and Heat Treatment of Titania Aerogels by Ambient Pressure Drying

Alumina-Doped Silica Aerogels for High-Temperature Thermal Insulation

Preparation of Alumina Aerogel via Supercritical Method

Grain boundary segregation for enhancing the thermal stability of alumina-mullite diphasic fibers by La2O3 addition

Preparation of monolithic Al2O3–SiO2 aerogels with high-temperature resistance using boehmite nanorods

Synthesis and characterization of SiO2-Al2O3 composite aerogel using inorganic aluminum salt as raw material

Synthesis of Alumina Aerogels by Ambient Drying Method and Control of Their Structures

Preparation and Characterization of Alumina-coated Hollow Quartz Fiber Reinforced Al2O3-SiO2 Aerogel Composite

Investigation on textural and structural evolution of the novel crack-free equimolar Al2O3-SiO2-TiO2 ternary aerogel during thermal treatment

Synthesis of monolithic aerogel-like alumina via the accumulation of mesoporous hollow microspheres

Novel Al2O3–SiO2 composite aerogels with high specific surface area at elevated temperatures with different alumina/silica molar ratios prepared by a non-alkoxide sol–gel method

Preparation of High-Temperature Resistant Aerogels by Incorporating Aluminum Sol into Composite Silica Sources Using Ambient Pressure Drying

Synthesis of a novel Al 2 O 3 –SiO 2 composite aerogel with high specific surface area at elevated temperatures using inexpensive inorganic salt of aluminum

A Facile Method to Fabricate Al2O3-SiO2 Aerogels with Low Shrinkage up to 1200 °C

Fabrication of Al2O3 aerogel-SiO2 fiber composite with enhanced thermal insulation and high heat resistance

Novel silica-modified boehmite aerogels and fiber-reinforced insulation composites with ultra-high thermal stability and low thermal conductivity

Postsynthetic modification of yttria‐stabilized zirconia aerogels with silica coatings for enhanced thermal stability

Effect of Titanium Dioxide Particles on the Thermal Stability of Silica Aerogels