Abstract:The transformation-assisted consolidation under pressure has been demonstrated to be a promising method to fabricate the nano or submicron polycrystalline ceramic materials. The high pressure suppresses the long-range diffusion of the atoms and, consequently, restrains the grain coarsening. The new phases produced at high pressure could show finer grains under the appropriate thermodynamic conditions, which are not subject to the grain size of the raw materials. Ceramic materials exhibit the existence of the transformations under certain thermodynamic conditions and the formation of new phases generally undergoes the nucleation and growth. In the present work, monoclinic microcrystal ZrO2 with average grain size of 2 µm and Y2O3 with average grain size of 50 nm were mixed in molar ratio of 97∶3. The preparation of the samples was carried out by sintering at 5.5 GPa and temperatures of 800–1700 °C using the high pressure cubic cell, and the sample characterization was performed via the X-ray diffraction, scanning electron microscope and transmission electron microscopy. It was found that the monoclinic and submicron tetragonal composite polycrystalline ZrO2 in bulk is obtained under high pressure and high temperature. The average grain size of tetragonal ZrO2 fabricated at 1200, 1400, 1600 and 1700 °C is (145±62) nm, (246±165) nm, (183±62) nm and (245±107) nm, respectively. The synthesis of the fine-grained polycrystalline materials by the transformation under high pressure can solve the problems of agglomeration, adsorption and grain coarsening caused by the nanopowders as the starting materials in the conventional approach, which would be an alternative route to fabricate the fine-grained polycrystalline materials with the enhanced performances.

Preparation and Microstructure of Nanometer Tetragonal Polycrystal Zirconia Powder at Low Temperature Condition

PREPARATION AND PROPERTIES OF NANOMETER POLYCRYSTALS ZIRCONIA POWDER BYSUPER ALKALINE METHOD AT LOW TEMPERATURE WITH ORGANIC ADDITIVES

Study on the process and properties of nano-sized polycrystal zirconia powders by co-precipitation in super-alkaline medium

Fabrication of Submicron Tetragonal Polycrystalline ZrO2 by the Transformation of Micro Monoclinic ZrO2 under High Pressure

Study on a new, environmentally benign method and its feasibility of preparing nanometer zirconia powder

The Process and Properties of Nanometer Zirconia Powder by Environmental Benign Method

Low Temperature Sintering of High Performance Al2O3/ZrO2 Ceramics with Ultra-Fine Nanoparticles Strengthening

Preparation of Zirconia Powders by Sol-gel Process

Optimization of the structure and morphology of monoclinic phase nanoscale zirconium dioxide

Phase Composition Controllable Preparation of Zirconia Nanocrystals Via Solvothermal Method

Preparation and Characterization of Nano-Sized Al2O3/ZrO2 Powders

LOW TEMPERATURE SYNTHESIS OF HIGH-PURITY ZIRCON POWDER BY A HYDROTHERMAL METHOD

Preparation of Nano-ZrO2 powder via a microwave-assisted hydrothermal method

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Preparation of Zirconia Base Solid Solution Nanopowder by Exothermal Solid-State Synthesis

Synthesis of the superfine high-entropy zirconate nanopowders by polymerized complex method

Nano-Zirconia/Mullite Composite Ceramics Prepared By In-Situ Controlled Crystallization From The Si-Al-Zr-O Amorphous Bulk

Preparation of spherical zirconia powder by nano-reactor of microemulsion and its densification behavior

Polymerizing Mechanism and Technical Factors Optimization of Nanometer Tetragonal Polycrystalline Zirconia Slurries for the Aqueous-Gel-tape-casting Process

Preparation of tetragonal CaO-ZrO2 nano-powder by chemical coprecipitation method

Effect of pH on crystallization of nanocrystalline zirconia in a microwave-hydrothermal process