Abstract:A novel hybrid electrochemical machining (ECM) approach combining a pulsed cathodic plasma and an electrochemical machining process, namely, plasma-assisted electrochemical machining (PA-ECM), is proposed in this study to strengthen the capacity of ECM, which entails both high efficiency and precision. The plasma characteristics, material removal behavior, surface topography and machining precision of PA-ECM for microtool fabrication are experimentally investigated under various conditions. The results show that PA-ECM can be realized under optimized electrical potentials with a vapor gaseous skin and electrolytic plasma layer formed around the cathode tool, of which the kinetic and thermal energies can enhance both the kinetics of the electrochemical reaction and mass transport during the ECM process. Through the design of the pulse voltage waveform, the formation and transportation of gaseous bubbles and plasmas can be well controlled. It has been shown that PA-ECM is effective and efficient for improving both the material removal rate and form accuracy in machining microtools. In the presence of plasma, a microrod tool with a high aspect ratio of 55:1 is successfully machined by PA-ECM in 5 s from its original diameter of 200 μm to approximately 18 μm, which seems to be the highest machining rate achieved so far. Additionally, in comparison to traditional ECM under the same conditions, PA-ECM provides a noticeable improvement in the microrod tool straightness error from 66.8 μm to 14.6 μm owing to the side surface insulation effect of the gaseous skin. The resulting surface roughness Ra is drastically reduced from 1096 nm to 46 nm, demonstrating that PA-ECM provides an innovative way to considerably improve the ECM efficiency without compromising the surface finish. Furthermore, the PA-ECM of microholes and microstructures are exhibited with improved precision, demonstrating the capacity of PA-ECM for micromachining.

ELECTROLYTIC MICROMACHINTNG WITH HIGH FREQUENCY SHORT PULSE CURRENT

Gap status identification and control of wire electrochemical micromachining

A study on wire electrochemical micromachining for fabrication of microgrooves

Electrochemical micro-machining of high aspect ratio micro-tools with a reverse conical shape tip using electrolyte liquid membrane

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

Sinking ECDM micro-milling of micro-channels with a customized electrode

Research on the Key Technologies of Micro Electro Discharge Machining

Machining performance enhancement of deep micro drilling using electrochemical discharge machining under magnetohydrodynamic effect

Investigation of the Material Removal Mechanism in Electrochemical Discharge Drilling Using a High-Speed Rotating Helical Tool-Electrode

Performance improvement of electrochemical micromachining employing pulse width modulation

Modeling and Fabrication of Microhole by Electrochemical Micromachining Using Retracted Tip Tool

Localized electrochemical micromachining with gap control

Plasma-assisted electrochemical machining of microtools and microstructures

Research on Electrochemical Machining with Synchronization of Pulse Current and Low-frequency Vibration

Research On Micro Ecm Using Micro Array Electrode

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

Wire Electrochemical Machining with Pulsating Radial Electrolyte Supply and Preparation of Its Tube Electrode with Micro-Holes

Micro Electro Machining Technologies for Industrial Application

Improving surface integrity of micro-holes in ECDM using ultrahigh-speed rotary of tool cathode and non-water-based electrolyte

Research on Improvement of Accuracy of Micro ECM with Multitechnique Integration

Characteristics for electrochemical machining with nanoscale voltage pulses