Abstract:In electrochemical machining (ECM) of micro holes with high aspect ratio, hollow electrodes are commonly utilized to remove electrolytic products from the inter-electrode gap. In this paper, the effect of electrolyte pressure through hollow electrode on shape accuracy is studied by both numerical simulations and experimental tests. The multi-physics models consisting of electric current field, electrolyte flow, gas diffusion and heat transfer are established by using COMSOL Multiphysics software. With the inlet pressure range of 0.25-1.15MPa employed, the material removal rate of workpiece is predicted. At different machining depths, the material removal rate of micro-hole bottom is in an increasing trend with the pressure increasing, which has a positive effect on machining stability. With the pressure increasing, the material removal rate of side wall is fluctuating. And the area of vortex zone in the machining gap increases. Consequently, the shape accuracy is deteriorated. From experimental results of reverse tapered holes, at a small machining depth, the shape accuracy is deteriorated (straightness error > 20μm) with excessive electrolyte pressure. When the hole is deep, the shape accuracy is deteriorated with low pressure because of electrolytic products blocking. The shape accuracy can be improved by changing the electrolyte pressure in optimal rules obtained from the simulated results. The proposed simulation model can be used as a predictive tool to provide optimal parameters for better shape accuracy in micro ECM. On 1.0mm thick 18CrNi8 workpiece, a reverse tapered hole with diameter of 175μm and taper angle of 1.12° is machined. The deviation between designed shape and experimental results is 4.2μm.

Modeling and Fabrication of Microhole by Electrochemical Micromachining Using Retracted Tip Tool

Electrochemical micro-machining of high aspect ratio micro-tools with a reverse conical shape tip using electrolyte liquid membrane

The Multi-Physics Analysis for a Novel Tool Structure to Improve the Accuracy in Electrochemical Micro-Machining

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

A study on wire electrochemical micromachining for fabrication of microgrooves

Multiphysics simulation and experimental investigation of microtool fabricated by EMM

Research on Ecm Process of Micro Holes with Internal Features

Research On Micro Electrode Fabrication Based On Ecm

Design of a Micro-hole EDM Tool and its Machining Experiments

Impact Analysis of Electrolyte Pressure on Shape Accuracy of Micro Holes in ECM with Hollow Electrodes

Theoretical and experimental study on micro ultrasonic-assisted electrochemical drilling with high speed electrode

Gap status identification and control of wire electrochemical micromachining

Research on Small-hole Manufacturing Process through Electrochemical Machining with Side-insulated Tool Electrode

Fabrication of Micro-Holes in PMMA Using Micro-ECDM Process: Geometric Characteristics and EC Discharge Behaviour

Machining performance enhancement of deep micro drilling using electrochemical discharge machining under magnetohydrodynamic effect

Review on role of electrical discharge drilling methods in fabricating micro holes: formation mechanism, defects characterization and mitigation strategies

Micro-EDM of micro-stepped hole based on the wear of micro-bit

Scanning Micro-Electrochemical Machining Process for V-Shaped Grooves

A Profile Shaping and Surface Finishing Process of Micro Electrochemical Machining for Microstructures on Microfluidic Chip Molds

Tooling aspects of micro electrochemical machining (ECM) technology: Design, functionality, and fabrication routes

An Analysis of the Uneven Tool Electrode Wear Mechanism in the Micro-electrical Discharge Machining Process