Abstract:Micro groove, as a typical surface texture, has played an important role in the development of many advanced fields. This paper introduced an electrochemical machining of micro groove using masked porous cathode. A porous metallic plate covered with a mask was prepared as the masked porous cathode. During machining, the masked porous cathode was covered on the workpiece, and the electrolyte could flow into the machining region through the porous structure in the cathode for machining. As the machining unit was closed, the distribution of electrical field was uniform on the machining surface, which could improve the machining accuracy. In addition, the masked porous mask had no damage during machining and could be reused, which improved the machining efficiency. With this method, multiphysics coupling model, including flow field model, electric current model, heat transfer model, reactant transport model, and moving mesh model, was built to investigate their influence on the machining process with different flow modes. The simulation and experiment results indicated that compared with other two flow modes, jet flow mode could provide a high electrolyte velocity in the machining region around the nozzle, and the mass transfer process was enhanced, which was helpful to improve the machining quality. The effect of pulse duty cycle was investigated, and the pulse duty cycle of 20% with the frequency of 2 kHz could further improve the mass transfer process and was preferred to generate micro groove with low standard deviation and roughness. In addition, with the applied voltage rising, the depth of micro groove increased, and increasing the nozzle reciprocating motion number could enhance the mass transfer process during machining, which further improved machining quality. Finally, with the optimized flow mode and machining parameters, a group of ten micro grooves were well generated by using a masked porous cathode with ten micro slits, and the width was about 330 μm with the depth of 45 μm.

A study on wire electrochemical micromachining for fabrication of microgrooves

Gap status identification and control of wire electrochemical micromachining

Scanning Micro-Electrochemical Machining Process for V-Shaped Grooves

Study on the Preparation Process for High Accuracy Micro Machining by Wire Electrical Discharge Machining

Enhancement of wire electrochemical micromachining of 40CrNiMoA with electrolyte ultrasonic assistance

Analysis and Reduction of Process Energy Consumption and Thermal Deformation in a Micro-Structure Wire Electrode Electric Discharge Machining Thin-Wall Component

Experimental Study of Electrical-Assisted Nanomachining of Monocrystalline Copper Using Customized Tungsten Tip

Electrochemical micro-machining of high aspect ratio micro-tools with a reverse conical shape tip using electrolyte liquid membrane

Electrochemical micromachining of ZrCu-based amorphous alloy in ethylene glycol solution

Micro-ultrasonic machining technology of diamond dies for drawing metal microwires

Localized electrochemical micromachining with gap control

Wire Electrochemical Machining with Pulsating Radial Electrolyte Supply and Preparation of Its Tube Electrode with Micro-Holes

Research on the Key Technologies of Micro Electro Discharge Machining

A Profile Shaping and Surface Finishing Process of Micro Electrochemical Machining for Microstructures on Microfluidic Chip Molds

Investigation on the electrochemical machining of micro groove using masked porous cathode

Fabrication of Microgrooves by Synchronous Hybrid Laser and Shaped Tube Electrochemical Milling

Characteristics for electrochemical machining with nanoscale voltage pulses

Research On Micro Electrode Fabrication Based On Ecm

Precision EDM of Micron-Scale Diameter Hole Array Using in-Process Wire Electro-Discharge Grinding High-Aspect-Ratio Microelectrodes

Investigation on pulse-vibration electrochemical machining of parallel micro-grooves

Helical Surface Creation by Wire Electrical Discharge Machining for Micro Tools