Abstract:Micro-electrical discharge machining (micro-EDM) is a good candidate for processing micro-hole arrays, which are critical features of micro-electro-mechanical systems (MEMS), diesel injector nozzles, inkjet printheads and turbine blades, etc. In this study, the wire vibration of the wire electro-discharge grinding (WEDG) system has been analyzed theoretically, and, accordingly, an improved WEDG method was developed to fabricate micron-scale diameter and high-aspect-ratio microelectrodes for the in-process micro-EDM of hole array with hole diameter smaller than 20 μm. The improved method has a new feature of a positioning device to address the wire vibration problem, and thus to enhance microelectrodes fabrication precision. Using this method, 14 μm diameter microelectrodes with less than 0.4 μm deviation and an aspect ratio of 142, which is the largest aspect ratio ever reported in the literature, were successfully fabricated. These microelectrodes were then used to in-process micro-EDM of hole array in stainless steel. The effects of applied voltage, current and pulse frequency on hole dimensional accuracy and microelectrode wear were investigated. The optimal processing parameters were selected using response–surface experiments. To improve machining accuracy, an in-process touch-measurement compensation strategy was applied to reduce the cumulative compensation error of the micro-EDM process. Using such a system, micro-hole array (2 × 80) with average entrance diameter 18.91 μm and average exit diameter 17.65 μm were produced in 50 μm thickness stainless steel sheets, and standard deviations of hole entrance and exit sides of 0.44 and 0.38 μm, respectively, were achieved.

Micro-ultrasonic machining technology of diamond dies for drawing metal microwires

The Ultra-precision Machining Technology and It' Domestic and International Progress

A study on wire electrochemical micromachining for fabrication of microgrooves

Study on the Preparation Process for High Accuracy Micro Machining by Wire Electrical Discharge Machining

Design of Ultrasonic Machining Device for Thin-Wall Cylinder of Air Compressor

Theoretical and experimental study on micro ultrasonic-assisted electrochemical drilling with high speed electrode

Helical Surface Creation by Wire Electrical Discharge Machining for Micro Tools

Experiment and Discussion on Ultrasonic Vibration-Assisted Single Point Diamond Turning of Die Steels

An Overview of Ultra-Precision Diamond Machining of Microstructured Freeform Surfaces

Precision EDM of Micron-Scale Diameter Hole Array Using in-Process Wire Electro-Discharge Grinding High-Aspect-Ratio Microelectrodes

Experimental investigation on cavitation effect and surface quality of ultrasonic-assisted micro-hole drilling

Research on the Key Technologies of Micro Electro Discharge Machining

Research on Geometric Constraint Strategies for Controlling the Diameter of Micro−Shafts Manufactured via Wire Electric Discharge Grinding

Study on Ultrasonic Driller for Microstructure Manufacture

Comparative Study of Ultrasonic Vibration-Assisted Die-Sinking Micro-Electrical Discharge Machining on Polycrystalline Diamond and Titanium

Experimental Research of High-Quality Drilling Based on Ultrasonic Vibration-Assisted Machining

Development of a high precision tabletop versatile CNC wire-EDM for making intricate micro parts

Dynamic chip formation of ultrasonic-assisted micro-drilling on AISI 4340 steel

A study of micro-EDM and micro-ECM combined milling for 3D metallic micro-structures

Analysis and Reduction of Process Energy Consumption and Thermal Deformation in a Micro-Structure Wire Electrode Electric Discharge Machining Thin-Wall Component

An overview to micro-wire-electrical discharge machining