Abstract:Micro groove, as a typical surface texture, has played an important role in the development of many advanced fields. This paper introduced an electrochemical machining of micro groove using masked porous cathode. A porous metallic plate covered with a mask was prepared as the masked porous cathode. During machining, the masked porous cathode was covered on the workpiece, and the electrolyte could flow into the machining region through the porous structure in the cathode for machining. As the machining unit was closed, the distribution of electrical field was uniform on the machining surface, which could improve the machining accuracy. In addition, the masked porous mask had no damage during machining and could be reused, which improved the machining efficiency. With this method, multiphysics coupling model, including flow field model, electric current model, heat transfer model, reactant transport model, and moving mesh model, was built to investigate their influence on the machining process with different flow modes. The simulation and experiment results indicated that compared with other two flow modes, jet flow mode could provide a high electrolyte velocity in the machining region around the nozzle, and the mass transfer process was enhanced, which was helpful to improve the machining quality. The effect of pulse duty cycle was investigated, and the pulse duty cycle of 20% with the frequency of 2 kHz could further improve the mass transfer process and was preferred to generate micro groove with low standard deviation and roughness. In addition, with the applied voltage rising, the depth of micro groove increased, and increasing the nozzle reciprocating motion number could enhance the mass transfer process during machining, which further improved machining quality. Finally, with the optimized flow mode and machining parameters, a group of ten micro grooves were well generated by using a masked porous cathode with ten micro slits, and the width was about 330 μm with the depth of 45 μm.

Characteristics for electrochemical machining with nanoscale voltage pulses

A study on wire electrochemical micromachining for fabrication of microgrooves

Pulse electrochemical meso/micro/nano ultraprecision machining technology

Experimental investigation of machined hole and optimization of machining parameters using electrochemical machining

Study of the Effect of Electric Field Distribution to the Pulse Electrochemical Machining

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

Recent trends on electro chemical machining process of metallic materials: a review

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

Electrochemical milling of deep-narrow slots with a pulsating electrolyte flow field

Electrochemical micro-machining of high aspect ratio micro-tools with a reverse conical shape tip using electrolyte liquid membrane

Localized electrochemical micromachining with gap control

Experimental Study of Electrical-Assisted Nanomachining of Monocrystalline Copper Using Customized Tungsten Tip

Precision Electrochemical Micro-Machining of Molybdenum in Neutral Salt Solution Based on Electrochemical Analysis

Effects of Machining Parameters on Electrochemical Multi-Field Coupling

Study on the Electrical and Geometrical Parameters of Micro Electrical Discharge Machining

Electrochemical machining of complex components of aero-engines: Developments, trends, and technological advances

Influence of Different Tool Electrode Materials on Electrochemical Discharge Machining Performances

Optimizing micro-EDM with carbon-coated electrodes: A multi-criteria approach

On electrochemical machining with an interelectrode slit for a partially insulating cathode

Investigation on the electrochemical machining of micro groove using masked porous cathode

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode