Abstract:The electrochemical discharge machining (ECDM) is an advanced and promising technology for fabricating micro structures. This method is effectively applicable for non-conductive hard and brittle materials micromachining, such as glass and ceramics. However, the ceramics high melting point and intense heat exchange effects during microchannel fabrication lead to the easy dissipation of thermal energy and the difficulty in processing. To address this issue and expanded the ECDM processing range. This paper dedicated to the investigation of the material removal mechanism and process characteristics for the alumina ceramic surfaces microchannels preparation. Firstly, this study explained the difference of the ECDM critical applied voltage and gas film generation mechanism by analyzing the volt-ampere characteristic curve of 20 wt% NaOH electrolyte with a tool immersed depth of 2 mm and 10 mm respectively. Then, a thermal removal finite element model (FEM) for ECDM was developed. The heat cumulative and intermittent cooling effects applied on the alumina ceramic surface dominated the materiel removal. Additionally, it can be found that the microchannel machining accuracy and bottom surface quality depended on the Gaussian heat source characteristics, gas film formation mechanism, heat accumulation effect, and temperatures spatial and temporal distribution. And a series of single factor experiments for evaluating the parametric studies such as the effect of discharge frequency, applied voltage, duty ratio and tool feed rate on the fabricated microchannel performance are executed. Finally, the complex three-dimensional structures of cross microchannel grid and zigzag microchannel array with variable depth were successfully fabricated on aluminum oxide ceramic surface. Notably, the results highlighted and enriched the ECDM stability, consistency and applicability for alumina ceramic surface microchannel fabrication.

Investigation of the Material Removal Mechanism in Electrochemical Discharge Drilling Using a High-Speed Rotating Helical Tool-Electrode

Insights into the high-speed electrochemical discharge drilling for film cooling hole: Machining phenomena, morphological evolution, and visualize simulation

Machining performance enhancement of deep micro drilling using electrochemical discharge machining under magnetohydrodynamic effect

Improving surface integrity of micro-holes in ECDM using ultrahigh-speed rotary of tool cathode and non-water-based electrolyte

Material wear of the tool electrode and metal workpiece in electrochemical discharge machining

High-speed Near Dry Electrical Discharge Machining

Influence of Different Tool Electrode Materials on Electrochemical Discharge Machining Performances

Vibration-assisted electrochemical discharge drilling method for microholes without recast layer

Experimental investigation of rotary sinking electrochemical discharge milling with high-conductivity salt solution and non-pulsed direct current

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

Review of electrochemical discharge machining technology for insulating hard and brittle materials

Chain discharging behavior induced by gas film expansion and its influence on the electrochemical discharge machining (ECDM) process

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode

Experimental and numerical investigations into the fabrication of alumina ceramic surface microchannel by electrochemical discharge machining

Self-adjusting EDM/ECM High Speed Drilling of Film Cooling Holes

Investigation through novel tool-electrode feeding approach on electrochemical discharge machining of glass

Experimental Study and Parameter Optimization on Sustainable and Efficient Machining GH4169 with Rotating Short Arc Milling Method

Electrochemical discharge machining grooves without recast layer in 20 wt% NaCl solution

Sinking ECDM micro-milling of micro-channels with a customized electrode

Performance improvement of high-speed EDM and ECM combined process by using a helical tube electrode with matched internal and external flushing

A Hybrid Process of Electrochemical Discharge Machining (ECDM) and High-Speed Milling (HSM) on Quartz Glass