Abstract:In order to achieve the ultra-clean emission standards, many power plants in China have completed the installation of low-low temperature flue gas system. However, during the operation of this system, many problems have emerged, such as the ash deposition problem in the heat exchanger and dry ESP (electrostatic precipitator). In this paper, the fixed adsorption system and entrained flow experimental system were built to study the ash deposition characteristics in low-low temperature flue gas system under different temperatures and particle sizes. The repose angle was measured to evaluate the flowability and adhesion capacity of ash particles. The results show that as the increase of adsorption time, the particle size increased gradually, and the agglomeration effect is attenuated after the particles have reached adsorption saturation. The time at which the ash particles began to agglomerate with each other was defined as the agglomeration threshold. As the adsorption temperature decreased, the particle size growth rate increased. The smaller the size of ash particles, the more significant the agglomeration effect. Large particles were easy to adsorb small particles, but the agglomeration effect between large particles was weak. In addition, in the initial stage of particle agglomeration, it was mainly included the adhesion between smaller particles and the adhesion of smaller particles on the surface of large particles. The followability of the ash particles was greatly reduced after the adsorption and agglomeration process. The repose angle of the ash particles increased as the temperature of the flue gas decreased. The smaller the particle size, the larger the repose angle changes, and the more pronounced the repose angle is influenced by the adsorption temperature. The flue gas temperature cannot be blindly dropped in pursuit of high sulfur oxide removal efficiency and dust removal efficiency.

INVESTIGATION ON ASH FOULING FORMATION OF INDUCED FAN BLADE AND HEAT EXCHANGER SURFACE IN A 1000 MW COAL-FIRED POWER PLANT

Investigation on ash fouling formation of induced fan blade and heat exchanger surface in a 1000MW coal-fired power plant

Study of ash fouling on the blade of induced fan in a 330 MW coal-fired power plant with ultra-low pollutant emission

Analysis on Ammonium Sulfate Deposition in Tail Flue of a 1000-MW Ultra-supercritical Coal-Fired Unit

Analysis of Formation and Growth Process of Ash Deposition on the Convective Heating Surface of a 400t/d MSW Incinerator Based on Different Operating Days

Characterization of the ash deposits along deep-cooling of the exhaust gas in coal-fired power plants

Field Study on the Corrosion and Ash Deposition of Low-Temperature Heating Surface in a Large-Scale Coal-Fired Power Plant

Study on Deposits Containing Rich Fluorine, Boron, and Ammonium on the Heating Surface of a Flue Gas Cooler in a 300 MW Coal-Fired Boiler

Investigation into the Ash Deposits in a Coal-Fired Traveling Grate Boiler with Ammonia Present in the Flue Gas

Investigation on the influence of sulfur and chlorine on the initial deposition/fouling characteristics of a high-alkali coal

An Experimental Study on Ash Deposition Problem of Low-Low Temperature Flue Gas System

Investigation of Ash Deposition Characteristics in Full-Scale Circulating Fluidized Bed Boiler Burning Zhundong Coal

Ash Deposition of Zhundong Coal in a 350 MW Pulverized Coal Furnace: Influence of Sulfation

Fouling of the flue gas cooler in a large-scale coal-fired power plant

Ash fouling, deposition and slagging in ultra-supercritical coal power plants

Ash Deposition Mechanism and Composition Distribution Characteristics in Oil-fired Boiler

Analysis on Deposition Mechanism of Ash with High Ash Fusion Temperatures on the Heat-insulation Layer in Boiler

Study on the Formation Process of Low‐temperature Ash Deposition Induced by Ammonium Bisulfate in Pulverized Coal‐fired Boiler

ICOPE-15-C055 Investigation on Slagging and Fouling of HRSG for Ferrosilicon Electric Furnace

ICOPE-15-C103 Mechanism Analysis of Surface Deposition Layer on the Flue Gas Cooler Caused by Ammonia Escape

Effect of Fouling Layer (Acid–Ash Reaction) on Low-Temperature Corrosion Covering Heating Surface in Coal-Fired Flue Gas