Ash Deposition Mechanism and Composition Distribution Characteristics in Oil-fired Boiler

ZHOU Jun-hu,ZHAO Xiao-hui,LI Yan-chang,CAO Xin-yu,CHENG Jun,LIU Jian-zhong,CEN Ke-fa
DOI: https://doi.org/10.3321/j.issn:0258-8013.2007.05.010
2007-01-01
Abstract:Ash deposits samples at different locations in a oil-fired boiler,which has suffered severe ash deposition problem,were studied to investigate the mechanism controlling the deposition in different deposition stages and at different zones.The XRF,SEM-EDAX and XRD techniques were used to identify the elemental composition,morphorlogy and mineralogy characteristics respectively.Two typical mature samples which were kept undisturbed were embeded in epoxy resin and then polished,subjected to SEM-EDAX analysis to quantify the elemental composition in the different layers in the direction of deposits growth.The results indicated that in the initial particulate layer,the major elemental content,viz.V,S,Na,Ca,Fe are much higher than the outer layer,while Si and Al show the adverse tendency.This may be due to the vaporized SO3 and V2O5 and the molten Fe2O3 or SiO2 particles covered by melten Fe2O3,which are transferred and then adhered to the deposit surface mainly by the following two machenisms,viz.thermophoresis and condensation.The major minerals in deposits at the water-wall zone is mullite,while for samples from the secondary superheater tube bank(at the furnace exit),besids mullite there are considerable cristobalite and microcline(potassium aluminosili-cates).Some vanadium oxide or salt(i.e.NiV3O8,NaV6O15 and Fe0.125V2O5)are detected for samples from primary superheater tube bank and the econo-mizer zones.
What problem does this paper attempt to address?