Abstract:This paper reports a novel oscillation control algorithm for MEMS vibratory gyroscopes using a modified electromechanical amplitude modulation (MEAM) technique, which enhances the robustness against the frequency variation of the driving mode, compared to the conventional EAM (CEAM) scheme. In this approach, the carrier voltage exerted on the proof mass is frequency-modulated by the drive resonant frequency. Accordingly, the pick-up signal from the interface circuit involves a constant-frequency component that contains the amplitude and phase information of the vibration displacement. In other words, this informational detection signal is independent of the mechanical resonant frequency, which varies due to different batches, imprecise micro-fabrication and changing environmental temperature. In this paper, the automatic gain control loop together with the phase-locked loop are simultaneously analyzed using the averaging method and Routh–Hurwitz criterion, deriving the stability condition and the parameter optimization rules of the transient response. Then, a simulation model based on the real system is set up to evaluate the control algorithm. Further, the proposed MEAM method is tested using a field-programmable-gate-array based digital platform on a capacitive vibratory gyroscope. By optimizing the control parameters, the transient response of the drive amplitude reveals a settling time of 45.2 ms without overshoot, according well with the theoretical prediction and simulation results. The first measurement results show that the amplitude variance of the drive displacement is 12 ppm in an hour while the phase standard deviation is as low as 0.0004°. The mode-split gyroscope operating under atmospheric pressure demonstrates an outstanding performance. By virtue of the proposed MEAM method, the bias instability and angle random walk are measured to be 0.9° h−1 (improved by 2.4 times compared to the CEAM method) and 0.068° (√h)−1 (improved by 1.4 times), respectively.

Force Rebalance Control for a MEMS Gyroscope Using Ascending Frequency Drive and Generalized PI Control

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

Analysis and Suppression of Rotor Eccentricity Effects on Fundamental Model Based Sensorless Control of Permanent Magnet Synchronous Machine

MEMS gyroscopes parametric excitation control scheme with constant resonant frequency

An Enhanced Sensorless Control Scheme for PMSM Drives Considering Self-inductance Asymmetry

A Sub-0.1°/H Bias-Instability MEMS Gyroscope Using Resonant Constant-Frequency Driving Technique

A 0.09°/h Bias-Instability MEMS Gyroscope Working with a Fixed Resonance Frequency

Drive Mode Control for MEMS Gyroscopes with Electrostatically Tunable Structure

A Real-Time Temperature Compensation Algorithm for a Force-Rebalanced MEMS Capacitive Accelerometer Based on Resonant Frequency.

Novel control strategy of force-balance accelerometers for measurement error minimization

Design and Test of MEMS Gyroscope Control System Based on LMSD

Noise Analysis and Modeling for a Digital Control Architecture for Lissajous Frequency-Modulated MEMS Gyroscope with Amplitude-Modulated Readout

Fuzzy Sliding-Mode Control of the Electrostatically Tuned Quasi-Zero Stiffness MEMS Accelerometer.

Constant-frequency Oscillation Control for Vibratory Micro-Machined Gyroscopes

Force Rebalance Controller Synthesis for A Micromachined Vibratory Gyroscope Based on Sensitivity Margin Specifications

A novel narrow-band force rebalance control method for the sense mode of MEMS vibratory gyroscopes

Four-Factor Polarity Switching Control for Synchronous Vibration Suppression of Active Magnetic Bearings Rigid Rotors System in the Full Rotational Speed Range.

A novel oscillation control for MEMS vibratory gyroscopes using a modified electromechanical amplitude modulation technique

Electrical Coupling Suppression and Transient Response Improvement for A Microgyroscope Using Ascending Frequency Drive with A 2-Dof Pid Controller

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

An Electrical-Coupling-suppressing MEMS Gyroscope with Feed-Forward Coupling Compensation and Scalable Fuzzy Control