Abstract:This paper presents a detailed study on the transient response and stability of the automatic gain control (AGC) with a proportion-integral (PI) controller for a MEMS vibratory gyroscope, which constructs a closed-loop control system to make the gyroscope achieve a constant amplitude vibration at its resonant frequency. The nonlinear mathematical model for the control system is established by applying the averaging and linearization method, which is evaluated through numerical simulations. The stability and convergence characteristics of the whole loop are investigated by using the phase plane method and Routh-Hurwitz criterion. The analysis provides a quantitative methodology for selecting the system parameters to approach stability and an optimal transient response. The negative impact induced by drift of the resonant frequency and Q-factor is also discussed. Simulation results predicted by the model are shown to be in close agreement with the experimental results carried out on a doubly decoupled bulk micromachined gyroscope. By optimizing the control parameters, the measured rising time is less than 100 ms without obvious overshoot. The setting time of the whole loop is less than 200 ms with the relative fluctuation of velocity amplitude within approximately 16 ppm for an hour. The resulting overall performance of the gyroscope is tested under atmospheric pressure. The resonant frequencies and the Q-factor of the drive mode and sense mode are 2.986 kHz, 213 and 3.199 kHz, 233, respectively. The gyroscope achieves a scale factor of 27.6 mV/deg/s with nonlinearity less than 120 ppm in the full-scale range of 800 degrees s(-1). The threshold of sensitivity is measured to be about 0.005 degrees s(-1) with noise equivalent angular rate evaluated to be 0.001 degrees/s/Hz(1/2).

Electrical Coupling Suppression and Transient Response Improvement for A Microgyroscope Using Ascending Frequency Drive with A 2-Dof Pid Controller

Improvement of transient response for drive loop of microgyroscope using 2-DOF PID controller

Constant-frequency Oscillation Control for Vibratory Micro-Machined Gyroscopes

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

MEMS gyroscopes parametric excitation control scheme with constant resonant frequency

Analysis on Digital Automatic Gain Control of MEMS Gyro Driven-Loop Circuit

One-time Frequency Sweep to Eliminate IQ Coupling in MEMS Vibratory Gyroscopes

Drive Mode Control for MEMS Gyroscopes with Electrostatically Tunable Structure

An Electrical-Coupling-suppressing MEMS Gyroscope with Feed-Forward Coupling Compensation and Scalable Fuzzy Control

Frequency Tuning Control for the Drive Mode of a Bulk Z-axis Micro-machined Gyroscope

Decoupling Control of Micromachined Spinning-Rotor Gyroscope with Electrostatic Suspension

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Transient response and stability of the AGC-PI closed-loop controlled MEMS vibratory gyroscopes

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Digital Control and Performance Test of a Symmetrical Doubly Decoupled Micro-Machined Gyroscope

High-Bandwidth Frequency Servo Loop for Resonant Micro Optic Gyroscope with a Reduced Sampling Rate Proportional-Derivative Controller

Precision Analysis of Frequency Lock-in Technique in Resonator Micro Optic Gyroscope

Study on electrostatic self-excited driving for tuning fork micromachined gyroscope with large Q value

Digital closed-loop controller design of a micromachined gyroscope based on auto frequency swept

A Temperature Control System Used for Improving Resonant Frequency Drift of MEMS Gyroscopes.

Decoupled Z-Axis Microgyroscope Using Oblique Comb For Frequency Tuning