Abstract:This paper presents a detailed study on the transient response and stability of the automatic gain control (AGC) with a proportion-integral (PI) controller for a MEMS vibratory gyroscope, which constructs a closed-loop control system to make the gyroscope achieve a constant amplitude vibration at its resonant frequency. The nonlinear mathematical model for the control system is established by applying the averaging and linearization method, which is evaluated through numerical simulations. The stability and convergence characteristics of the whole loop are investigated by using the phase plane method and Routh-Hurwitz criterion. The analysis provides a quantitative methodology for selecting the system parameters to approach stability and an optimal transient response. The negative impact induced by drift of the resonant frequency and Q-factor is also discussed. Simulation results predicted by the model are shown to be in close agreement with the experimental results carried out on a doubly decoupled bulk micromachined gyroscope. By optimizing the control parameters, the measured rising time is less than 100 ms without obvious overshoot. The setting time of the whole loop is less than 200 ms with the relative fluctuation of velocity amplitude within approximately 16 ppm for an hour. The resulting overall performance of the gyroscope is tested under atmospheric pressure. The resonant frequencies and the Q-factor of the drive mode and sense mode are 2.986 kHz, 213 and 3.199 kHz, 233, respectively. The gyroscope achieves a scale factor of 27.6 mV/deg/s with nonlinearity less than 120 ppm in the full-scale range of 800 degrees s(-1). The threshold of sensitivity is measured to be about 0.005 degrees s(-1) with noise equivalent angular rate evaluated to be 0.001 degrees/s/Hz(1/2).

Analysis on Digital Automatic Gain Control of MEMS Gyro Driven-Loop Circuit

Constant-frequency Oscillation Control for Vibratory Micro-Machined Gyroscopes

Design and Test of MEMS Gyroscope Control System Based on LMSD

Performance Improvement for MEMS Gyroscopes by Suppressing the Circuit Phase Delay

Drive Mode Control for MEMS Gyroscopes with Electrostatically Tunable Structure

Analysis and Design of Drive Closed-Loop for Mems Vibratory Gyroscope

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

Noise Analysis and Modeling for a Digital Control Architecture for Lissajous Frequency-Modulated MEMS Gyroscope with Amplitude-Modulated Readout

One-time Frequency Sweep to Eliminate IQ Coupling in MEMS Vibratory Gyroscopes

A Novel Amplitude-Phase Information Extraction Architecture for MEMS Vibratory Gyroscopes Using a Modified Double Side-Band Demodulation Configuration

MEMS gyroscopes parametric excitation control scheme with constant resonant frequency

An Improved Phase Lock Loop for Micromechanical Gyroscope with A Carrier Modulation

An Improved Phase-Robust Configuration for Vibration Amplitude-Phase Extraction for Capacitive MEMS Gyroscopes

Effects Of Both The Drive- And Sense-Mode Circuit Phase Delay On Mems Gyroscope Performance And Real-Time Suppression Of The Residual Fluctuation Phase Error

The Analysis and Design of Closed-Loop Control System for MEMS Vibratory Gyroscopes

Transient response and stability of the AGC-PI closed-loop controlled MEMS vibratory gyroscopes

Analysis and design of a 3rd order velocity-controlled closed-loop for MEMS vibratory gyroscopes

Digital Closed-Loop Control Based on Adaptive Filter for Drive Mode of a MEMS Gyroscope

Digital closed-loop controller design of a micromachined gyroscope based on auto frequency swept

Theoretical Analysis and Numerical Simulation of Closed-Loop Self-Oscillation System for MEMS Vibratory Gyroscopes

Design of Digital Demodulation Circuit for Closed Loop Control of Resonant MEMS Gyroscopes