Abstract:We set up a broadened resonator optic gyroscope (ROG) feedback loop model with the noise sources including a standard data acquisition (DAQ) board induced electric circuit noise, photo-detector (PD) noise and laser frequency noise, to predict, explain, and further optimize the system performance. Based on this model and combining with experimental tests, the characteristics of these three noises in ROG is analysed and optimized, and how the noises transfer in feedback state is discussed. The system with feedback loop shows strong rejection to electric circuit noise and laser frequency noise in the system output bandwidth, but nearly no effect on the power of PI) noise. For the whole noise power spectrum, larger loop delay and system output bandwidth induces more power for all the three noise sources, and larger loop gain induces less power for both electric circuit and laser frequency noises but more power for PI) noise. The sum of the three noises equivalent rotation is predicted and optimized by choosing different loop gain, loop delay and output bandwidth, and it is concluded that for a resonator micro-optic gyroscope (RMOG) with a 7.9 cm perimeter resonator, if the system loop delay decreases to 1 mu s and gain increases to 1.6 x 10(7), the noise equivalent rotation caused by laser frequency noise and PD noise will be down to 2.66 degrees/h with 10.00 Hz output bandwidth.

Precision Analysis of Frequency Lock-in Technique in Resonator Micro Optic Gyroscope

Optimization of the Resonant Frequency Servo Loop Technique in the Resonator Micro Optic Gyro

Design of High Frequency Lock-in Amplifier Applied in R-MOG

Reduction of High-Frequency Laser Noise in Resonant Fiber Optic Gyroscope with a Phase-Modulated Feedback Loop

Frequency Locking Technique in Digital Closed-Loop Resonator Fiber Optic Gyro

Characteristic Analysis of Noise in a Resonator Optic Gyroscope (ROG) Using a Feedback Loop

Laser Frequency Noise Measurement in a Resonant Fiber Optic Gyro

An Open-Loop RFOG Based on 2nd/4th Harmonic Feedback Technique to Suppress Phase Modulation Index’s Drift

Resonator micro optic gyro with double phase modulation technique using an FPGA-based digital processor

Analysis on Phase Modulation Spectroscopy of Resonator Fiber Optic Gyro

Optimization Of Frequency Stabilization Loop For Resonator Fiber Optic Gyro

Eliminating bias drift error in lock-in frequency for a resonant fiber optic gyro.

Evaluation and Measurement of the Lock-in Effect in Resonant Fiber Optic Gyroscopes

Full Investigation of the Resonant Frequency Servo Loop for Resonator Fiber-Optic Gyro.

Low-Noise Low-Delay Digital Signal Processor for Resonant Micro Optic Gyro

Synchronous In-Phase and Quadrature Demodulation Technique for Resonant Micro-Optic Gyroscope.

Reduction of the Effect of the Overflow Reset in Resonant Frequency Servo Loop for Resonator Fiber Optic Gyro

System Design on the Resonator Micro-Optic Gyro

Evaluation and Suppression of the Effect of Laser Frequency Noise on Resonant Fiber Optic Gyroscope

Research Progress of the Resonant Fiber Optic Gyroscope Technology

Laser Frequency Noise Power Spectral Density Measurement Technology and Its Application to Resonant Optical Fiber Gyroscope