Abstract:We set up a broadened resonator optic gyroscope (ROG) feedback loop model with the noise sources including a standard data acquisition (DAQ) board induced electric circuit noise, photo-detector (PD) noise and laser frequency noise, to predict, explain, and further optimize the system performance. Based on this model and combining with experimental tests, the characteristics of these three noises in ROG is analysed and optimized, and how the noises transfer in feedback state is discussed. The system with feedback loop shows strong rejection to electric circuit noise and laser frequency noise in the system output bandwidth, but nearly no effect on the power of PI) noise. For the whole noise power spectrum, larger loop delay and system output bandwidth induces more power for all the three noise sources, and larger loop gain induces less power for both electric circuit and laser frequency noises but more power for PI) noise. The sum of the three noises equivalent rotation is predicted and optimized by choosing different loop gain, loop delay and output bandwidth, and it is concluded that for a resonator micro-optic gyroscope (RMOG) with a 7.9 cm perimeter resonator, if the system loop delay decreases to 1 mu s and gain increases to 1.6 x 10(7), the noise equivalent rotation caused by laser frequency noise and PD noise will be down to 2.66 degrees/h with 10.00 Hz output bandwidth.

System Design on the Resonator Micro-Optic Gyro

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

Open-loop Operation Experiments in a Resonator Fiber-Optic Gyro Using the Phase Modulation Spectroscopy Technique.

Open-loop Experiments of Resonator Micro-Optic Gyro

Resonant Micro-Optic Gyro Using a Short and High-Finesse Fiber Ring Resonator

Reduction of High-Frequency Laser Noise in Resonant Fiber Optic Gyroscope with a Phase-Modulated Feedback Loop

Precision Analysis of Frequency Lock-in Technique in Resonator Micro Optic Gyroscope

Broadband Source-Driven Resonant Micro-Optic Gyroscope Based on a Multi-Turn Waveguide-Type Ring Resonator

Performance of Closed-Loop Resonant Micro Optic Gyro with Hybrid Digital Phase Modulation

Resonator micro optic gyro with double phase modulation technique using an FPGA-based digital processor

Synchronous In-Phase and Quadrature Demodulation Technique for Resonant Micro-Optic Gyroscope.

An Open-Loop Test of a Resonator Fiber Optic Gyro

Optimization of the Resonant Frequency Servo Loop Technique in the Resonator Micro Optic Gyro

Experiments by PM Spectroscopy in Resonator Fiber Optic Gyro

Design of High Frequency Lock-in Amplifier Applied in R-MOG

Resonant Micro Optic Gyro Using Tens of Centimeters Long Optical Fiber Coil

Characteristic Analysis of Noise in a Resonator Optic Gyroscope (ROG) Using a Feedback Loop

Low-Noise Low-Delay Digital Signal Processor for Resonant Micro Optic Gyro

Resonant Fiber Optic Gyro Based on A Sinusoidal Wave Modulation and Square Wave Demodulation Technique

Research Progress of the Resonant Fiber Optic Gyroscope Technology

Double Closed-Loop Resonant Micro Optic Gyro Using Hybrid Digital Phase Modulation.