A Low-Complexity In-Run Modal Frequency Tuning Method for MEMS Disk Gyroscopes Without Gain Calibration and Phase Shifting
Jia Jia,Ziqi Song,Yang Gao,Shixuan Gao,Huiliang Cao
DOI: https://doi.org/10.1109/tim.2024.3390164
IF: 5.6
2024-04-30
IEEE Transactions on Instrumentation and Measurement
Abstract:The approach of obtaining modal frequency split information using conventional sideband excitation signals requires gain calibration and compensation, and sense mode output signals as the frequency split decreases produce a phase shifting, which increases the complexity of the in-run modal frequency tuning (MFT) method for MEMS gyroscope. In this article, an in-run MFT system based on multiple frequency sideband excitation (MFSE) signals and preset stiffness regulation voltages (quadrature stiffness correction and frequency tuning voltages) is designed and implemented. The frequencies of MFSE signals are proportional to the drive modal frequency and eliminating the need for gain calibration of the MFT system. The preset stiffness regulation voltages are adopted to control the initial frequency split within 0.1 Hz, so that the phase of demodulation reference signals for sense mode remains fixed during the frequency tuning processing. First, the conditions of modal frequency matching are analyzed based on the stiffness regulation electrodes. Second, the necessity of modal frequency matching is investigated from the perspectives of signal acquisition and mechanical sensitivity. Third, the in-run MFT system is designed. Finally, the static performance of the disk gyroscope before and after modal frequency matching is compared. Bias instability (BI) is reduced from 3.543 to 0.902°/h, and angular random walk is reduced from 0.646 to , achieving the static performance of the tactical-grade gyroscope.
engineering, electrical & electronic,instruments & instrumentation