Abstract:This paper reports a novel MEMS accelerometer whose effective stiffness can be adjusted flexibly and even tuned to almost zero by using the electrostatic softening effect of two parallel plate capacitors: the comb-finger capacitor and the triangular capacitor. When applied to a biased voltage, the comb-finger capacitor provides a relatively large and nonlinear negative stiffness in the gap-varying direction, while the triangular capacitor produces a small yet linear negative stiffness in the area-varying direction. The proposed accelerometer is fabricated by using a standard silicon-on-glass manufacturing process and controlled by a customized digital circuit. An analytical model based on the pull-in dynamics as a result of the stiffness tuning is developed and simulated to investigate the dynamic behavior of the nonlinear accelerometer system. The proportion integral differential controller is utilized to improve the performance of the accelerometer while maintaining the stability of the closed-loop system operating with extremely low effective stiffness. The experimental results indicate that a two-fold increase of the sensitivity, a 30% reduction of Allan deviation bias instability, and a 20% reduction of Allan velocity random walk are achieved for the open-loop accelerometer system. A 75% decrease of the standard deviation bias instability and nearly two orders of magnitude improvement of the noise floor at 1 Hz for the closed-loop accelerometer system are realized when the effective stiffness is reduced to almost zero.

Acceleration-insensitive fully-decoupled tuning fork (FDTF) MEMS vibratory gyroscope with 1°/HR BIAS instability

Design and implementation of a fully-decoupled tuning fork (FDTF) MEMS vibratory gyroscope for robustness improvement

A 0.09°/h Bias-Instability MEMS Gyroscope Working with a Fixed Resonance Frequency

A Sub-0.1°/H Bias-Instability MEMS Gyroscope Using Resonant Constant-Frequency Driving Technique

A MICROMECHANICAL MODE-MATCHED GYROSCOPE USING STIFFNESS NONLINEARITY AND ELECTROSTATIC TUNING

A Stiffness-Tunable MEMS Accelerometer

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

A Slot-Structure MEMS Gyroscope Working at Atmosphere With Tunable Electrostatic Spring Constant

Effects of Structural Dimension Variation on the Vibration of MEMS Ring-Based Gyroscopes

A Stiffness-tunable MEMS Accelerometer with In-operation Drift Compensation

Optimization of Sensitivity for a Novelly-Designed MEMS Resonant Gyroscope

A lateral-axis micromachined tuning fork gyroscope with novel driving and sensing combs

A Lateral-Axis Micromachined Tuning Fork Gyroscope With Torsional Z-Sensing And Electrostatic Force-Balanced Driving

A Wafer-Level Vacuum Packaged MEMS Disk Resonator Gyroscope With 0.42°/h Bias Instability Within ±300°/s Full Scale

A toroidal SAW gyroscope with focused IDTs for sensitivity enhancement

A lateral-axis tuning fork gyroscope with combined sensing capacitors and decoupled comb drive

Design and optimization of a resonant output frequency gyroscope for robust sensitivity and bandwidth performance

A Lateral-Axis Microelectromechanical Tuning-Fork Gyroscope With Decoupled Comb Drive Operating at Atmospheric Pressure

A Low-Complexity In-Run Modal Frequency Tuning Method for MEMS Disk Gyroscopes Without Gain Calibration and Phase Shifting

Vibration Sensitivity Reduction of Micromachined Tuning Fork Gyroscopes through Stiffness Match Method with Negative Electrostatic Spring Effect

A tuning fork gyroscope with drive-sense orthogonal thin-walled holes for high sensitivity