Abstract:High strength steels have been applied more and more widely in steel structures in the world. In China, Q420 steel angle members with the nominal yield strength of 420MPa have been applied in many steel structures especially in transmission towers. However, there is lack of study on its residual stress, which is one of the most important imperfections and has significant effects on the buckling behavior of steel members. The previous research works were only based on ordinary strength steels, whose yield strength is around 200MPa, and the distribution models of the residual stress in many countries' steel structures design codes are only applicable for ordinary strength steel members. Consequently, the study on the residual stress of high strength steel sections is quite necessary. Some measuring tests on high strength steel welded box and I sections have been conducted before, but no hot-rolled sections. In this paper, the residual stress measuring test for Q420 steel equal angle sections is conducted. Sectioning method is used, and there are 5 different sections with a total of 15 specimens were measured. Based on the test results, the characteristics of the residual stress distribution of Q420 high strength steel equal angles are analyzed, as well as the magnitudes of the compressive and tensile residual stresses. Besides, the test results were compared with the residual stress distribution of ordinary strength steels. Finally, the effects of the widththickness ratio of the angle leg and the steel strength are discussed. The test results can be used to establish new distribution models of Q420 high strength steel equal angles and it can be applied in the buckling analysis of such kind of angle members.

EXPERIMENTAL STUDY ON THE RESIDUAL STRESS OF Q420 LARGE-SECTION HOT-ROLLED AND GALVANIZED STEEL EQUAL LEG ANGLES

Experimental Study and Modeling of Residual Stresses of Q420 Large-Section Angles

Experiments on the residual stress of 420MPA steel equal angles

Residual stress tests of high-strength steel equal angles

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

EXPERIMENTAL AND UNIFIED MODEL INVESTIGATIONS ON RESIDUAL STRESS WITHIN HIGH STRENGTH STEEL WELDED I-SECTIONS

Residual Stress of 460mpa High Strength Steel Welded Box Section: Experimental Investigation and Modeling

Fine analysis of section stress of steel strand

RESIDUAL STRESS OF WELDED I SECTIONS FABRICATED FROM HIGH PERFORMANCE STEEL: EXPERIMENTAL INVESTIGATION AND MODELLING

Investigation on residual stress in Q460 high strength steel welded box sections

Experimental Investigation and Modeling on Residual Stress of Welded Steel Circular Tubes

Numerical Study on Welding Residual Stress Distribution of Corrugated Steel Webs

Residual Stress Of High Strength Steel Welded Sections

Residual Stress Distributions in Welded Stainless Steel Sections

Residual stress model of welded steel L-shaped and T- shaped sections

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Residual stress and compression buckling of large welded equal-leg steel angles

Experimental study on residual stress in 960MPa high strength steel welded box sections and unified model

EXPERIMENTAL STUDY ON RESIDUAL STRESS OF AUSTENITIC STAINLESS STEEL 316 IN FABRICATED I-SECTIONS

Experimental and numerical study on welding residual stress of U-rib stiffened plates

Measurement and distribution models of residual stresses in welded stainless steel box sections