Abstract:With the progress in metallurgical technique and steel production process, the strength of structural steels can be improved, along with other material properties, including higher toughness and better weldability. Meanwhile, there are numerous potential civil structural applications for high strength steel (HSS), such as large-span space frames, transfer truss in high-rise buildings, as well as truss bridges. The mechanical behavior of structural members made up from HSS must be closely investigated and quantified before HSS can be widely used in engineering structures. In this paper experiments on six Q550 HSS I-section beams under moment gradient (MG) and four Q550 HSS I-section beams under patch loading (PL) were carried out, to investigate the local buckling behavior of I-section beams subjected to different loading conditions. The failure modes, critical local buckling strengths, ultimate strengths, load–deformation curves, load–strain curves and moment–rotation curves of the specimens were obtained. The test results of ultimate strengths were further compared with the design results in accordance with the available design methods in current specifications, ANSI/AISC 360-16, Eurocode 3, AS 4100-1998, AIJ LSD 2010 and GB 50017-2003. Accounting for material nonlinearity, geometric imperfection and residual stress, finite element models were established and verified with the existing test results, which were used for the parametric analysis of two series of 240 beams. The parametric investigation focused on the effects of the material properties and component plate slenderness on the ultimate strengths of I-section beams under MG and the ones under PL. The comparisons between the parametric analysis results, test results and the design results from ANSI/AISC 360-16 and Eurocode 3 were also conducted.

Experimental Study and Modeling of Residual Stresses of Q420 Large-Section Angles

EXPERIMENTAL STUDY ON THE RESIDUAL STRESS OF Q420 LARGE-SECTION HOT-ROLLED AND GALVANIZED STEEL EQUAL LEG ANGLES

Residual stress tests of high-strength steel equal angles

Experiments on the residual stress of 420MPA steel equal angles

Fine analysis of section stress of steel strand

Residual stress and compression buckling of large welded equal-leg steel angles

Residual stress model of welded steel L-shaped and T- shaped sections

Residual Stress Of High Strength Steel Welded Sections

Numerical Investigations on Elastic Buckling and Hysteretic Behavior of Steel Angles Assembled Buckling-Restrained Braces

Experimental Investigation and Modeling on Residual Stress of Welded Steel Circular Tubes

EXPERIMENTAL AND UNIFIED MODEL INVESTIGATIONS ON RESIDUAL STRESS WITHIN HIGH STRENGTH STEEL WELDED I-SECTIONS

STUDY ON THE STABILITY DESIGN METHOD OF HIGH STRENGTH STEEL ANGLE MEMBERS UNDER AXIAL COMPRESSION

Residual Stress of 460mpa High Strength Steel Welded Box Section: Experimental Investigation and Modeling

Numerical study on the local buckling of 420MPA steel equal angle coloums under axial compression

Residual Stress Measurements and Modeling of Built-Up Box-T Sections

Local Buckling of Steel Equal Angle Members with Normal and High Strengths

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams

Experimental and numerical investigation on flexural-torsional buckling of Q460 steel beams

Experimental Study on Overall Buckling Behavior of Q420 High Strength Equal Angle Members under Axial Compression

Study on the Local Buckling Behavior of Steel Equal Angle Members under Axial Compression with the Steel Strength Variation

INVESTIGATION ON DESIGN METHOD OF OVERALL BUCKLING BEHAVIOUR FOR Q420 HIGH STRENGTH STEEL EQUAL-LEG ANGLE MEMBERS UNDER AXIAL COMPRESSION