Experiments on the local buckling of 420MPA steel equal angle columns under axial compression?
Gang Shi,Zhao Liu,Huiyong Ban,Yong Zhang,Yongjiu Shi,Yuanqing Wang
2009-01-01
Abstract:Local buckling behavior can be ignored for hot-rolled ordinary strength steel equal angle compression members, because the width-thickness ratio of the leg is small enough, not exceeding the limit value of the ratio, which is related to the steel strength. However, this may be not true for high strength steel equal angle members. With the development of steel structures, Q420 steel angle members with the nominal yield strength of 420MPa have begun to be widely used in China, especially in the transmission towers. Because of the high strength, the limit value of width-thickness ratio of the angle leg becomes smaller than that of ordinary steel strength, which causes that the width-thickness ratios of the leg for some hot-rolled steel angle sections exceed the limit value. Consequently, the local buckling behavior must be considered for the 420MPa steel equal angle members under axial compression, especially for those with small slenderness. This paper introduces an axial compression experiment of 420MPa steel equal angle columns, with the total number of 15 specimens, including 5 different sections, with small slenderness, whose width-thickness ratios of the leg all exceed the limit values specified in many countries' steel structures design codes. The test results show that the local buckling is significant and must be considered for the 420MPa steel equal angle columns under axial compression. Compared with the design strengths by the American and European steel structures design codes, the test strengths are higher a lot, which is consistent with the existing research results.