Experiments on the residual stress of 420MPA steel equal angles

Huiyong Ban,Gang Shi,Yongjiu Shi,Yuanqing Wang

2009-01-01

Abstract:High strength steels have been applied more and more widely in steel structures in the world. In China, Q420 steel angle members with the nominal yield strength of 420MPa have been applied in many steel structures especially in transmission towers. However, there is lack of study on its residual stress, which is one of the most important imperfections and has significant effects on the buckling behavior of steel members. The previous research works were only based on ordinary strength steels, whose yield strength is around 200MPa, and the distribution models of the residual stress in many countries' steel structures design codes are only applicable for ordinary strength steel members. Consequently, the study on the residual stress of high strength steel sections is quite necessary. Some measuring tests on high strength steel welded box and I sections have been conducted before, but no hot-rolled sections. In this paper, the residual stress measuring test for Q420 steel equal angle sections is conducted. Sectioning method is used, and there are 5 different sections with a total of 15 specimens were measured. Based on the test results, the characteristics of the residual stress distribution of Q420 high strength steel equal angles are analyzed, as well as the magnitudes of the compressive and tensile residual stresses. Besides, the test results were compared with the residual stress distribution of ordinary strength steels. Finally, the effects of the widththickness ratio of the angle leg and the steel strength are discussed. The test results can be used to establish new distribution models of Q420 high strength steel equal angles and it can be applied in the buckling analysis of such kind of angle members.