Abstract:High strength steels have been applied more and more widely in steel structures in the world. In China, Q420 steel angle members with the nominal yield strength of 420MPa have been applied in many steel structures especially in transmission towers. However, there is lack of study on its residual stress, which is one of the most important imperfections and has significant effects on the buckling behavior of steel members. The previous research works were only based on ordinary strength steels, whose yield strength is around 200MPa, and the distribution models of the residual stress in many countries' steel structures design codes are only applicable for ordinary strength steel members. Consequently, the study on the residual stress of high strength steel sections is quite necessary. Some measuring tests on high strength steel welded box and I sections have been conducted before, but no hot-rolled sections. In this paper, the residual stress measuring test for Q420 steel equal angle sections is conducted. Sectioning method is used, and there are 5 different sections with a total of 15 specimens were measured. Based on the test results, the characteristics of the residual stress distribution of Q420 high strength steel equal angles are analyzed, as well as the magnitudes of the compressive and tensile residual stresses. Besides, the test results were compared with the residual stress distribution of ordinary strength steels. Finally, the effects of the widththickness ratio of the angle leg and the steel strength are discussed. The test results can be used to establish new distribution models of Q420 high strength steel equal angles and it can be applied in the buckling analysis of such kind of angle members.

Residual stress tests of high-strength steel equal angles

Experiments on the residual stress of 420MPA steel equal angles

Experimental Study and Modeling of Residual Stresses of Q420 Large-Section Angles

EXPERIMENTAL STUDY ON THE RESIDUAL STRESS OF Q420 LARGE-SECTION HOT-ROLLED AND GALVANIZED STEEL EQUAL LEG ANGLES

Residual Stress Of High Strength Steel Welded Sections

Local Buckling of Steel Equal Angle Members with Normal and High Strengths

Tests and Finite Element Analysis on the Local Buckling of 420 MPa Steel Equal Angle Columns under Axial Compression

Testing, Modelling and Design of Aluminium Alloy Single-Angle Members Connected by One Leg under Eccentric Compression

Numerical study on the local buckling of 420MPA steel equal angle coloums under axial compression

Residual stress and compression buckling of large welded equal-leg steel angles

Experiments on the local buckling of 420MPA steel equal angle columns under axial compression?

EXPERIMENTAL AND UNIFIED MODEL INVESTIGATIONS ON RESIDUAL STRESS WITHIN HIGH STRENGTH STEEL WELDED I-SECTIONS

Study on the Local Buckling Behavior of Steel Equal Angle Members under Axial Compression with the Steel Strength Variation

Finite Element Analysis on the Local Buckling of High Strength Steel Members under Axial Compression

Study on the residual stress distribution of ultra-high–strength-steel welded sections

Numerical Investigations on Elastic Buckling and Hysteretic Behavior of Steel Angles Assembled Buckling-Restrained Braces

Column Buckling Tests of 420 Mpa High Strength Steel Single Equal Angles

RESIDUAL STRESS OF WELDED I SECTIONS FABRICATED FROM HIGH PERFORMANCE STEEL: EXPERIMENTAL INVESTIGATION AND MODELLING

Residual Stress of 460mpa High Strength Steel Welded Box Section: Experimental Investigation and Modeling

A review on buckling design research of high strength steel equal-leg angle members under axial compression

Residual stress model of welded steel L-shaped and T- shaped sections