Residual Stress Of High Strength Steel Welded Sections

Gang Shi,Hui-Yong Ban,Yong-Jiu Shi,Yuan-Qing Wang

2008-01-01

Abstract:High strength steels with nominal yield strength more than 460 MPa have begun to be applied in many steel structures including buildings and bridges. It was established from analytic modeling and testing that the buckling strength of columns fabricated from high strength steel exceeded that of columns of equal length and same cross section fabricated from ordinary steel when compared on a nondimensional basis, but the buckling behavior of high strength steel welded section columns has not been studied well because there is short of sound research on their residual stress distributions. In this paper the available many test measuring results of residual stresses of high strength steel member welded sections, including box, I and cruciform sections, have been reviewed, analyzed and compared. The factors which influence the residual stress distribution, e.g. the steel yield strength, the width-thickness ratio of the steel plate and the weld type, have been taken into account, and the relationships between these factors and the residual stress have been studied. Based on this and the related European, American and Chinese codes, the simplified residual stress distribution models for high strength steel welded sections have been suggested, which can be applied in the analysis on the buckling behavior of columns fabricated from such high strength steel sections.