Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In the present work, the process chain in tube production by roll forming of the steel 34MnB5 was examined in more detail. The process chain consisting of the steps (i) roll forming, (ii) HFI welding, and then (iii) straightening and final calibration was mapped using the finite element method. In addition to the pipe geometry, the residual stress distribution was considered as an essential target value for the assessment of the performance of the tubes under service conditions. The objective of the project is to describe the manufacturing process and thus the processing induced residual stress distributions as realistically as possible. For a more detailed characterization of the process and above all for the validation of the numerical simulations, experimental residual stress analyses were carried out for the final state of the tubes using complementary analysis methods. The contour method was used to determine the 2D-distribution of residual stresses across the transverse and longitudinal sections of the manufactured pipes. These measurements were supplemented by local residual stress analyses using the incremental hole drilling method and X-ray residual stress analyses. The work thus pursues both a methodical approach to the analysis of the internal stresses induced by the process using complementary methods and also a manufacturing approach to the analysis and evaluation of the production chain. In particular for the axial components of the residual stresses, it can be shown that experimentally determined residual stresses correlate well with the numerically calculated values. The contour method is excellently suited to monitor the uneven distribution of the internal stresses over the pipe cross-section. The results of the simulation show that the overall residual stress distribution that is determined using the contour method mainly results from the plastic strains introduced by the roll forming process. X-ray and hole drilling analyses are shown to be more suitable for measuring locally present residual stresses at defined positions on the outer tube surface. In this way it can be shown that the simulation approach described provides an accurate model of the process.

Experimental Investigation and Modeling on Residual Stress of Welded Steel Circular Tubes

Experimental study on the steel tube moment connections with modified cover-plated reinforcement

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Residual stress model of welded steel L-shaped and T- shaped sections

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Residual Stress of 460mpa High Strength Steel Welded Box Section: Experimental Investigation and Modeling

EXPERIMENTAL AND UNIFIED MODEL INVESTIGATIONS ON RESIDUAL STRESS WITHIN HIGH STRENGTH STEEL WELDED I-SECTIONS

Residual Stress Of High Strength Steel Welded Sections

Experimental Study and Modeling of Residual Stresses of Q420 Large-Section Angles

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

RESIDUAL STRESS OF WELDED I SECTIONS FABRICATED FROM HIGH PERFORMANCE STEEL: EXPERIMENTAL INVESTIGATION AND MODELLING

Numerical Study on Residual Stresses and Plastic Strains in Cold-Formed High-Strength Steel Circular Hollow Sections

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Measurement and distribution models of residual stresses in welded stainless steel box sections

Experimental and numerical analysis of residual stresses induced by the manufacturing process of longitudinal welded tubes

Residual Stress Distributions in Welded Stainless Steel Sections

Experimental study on residual stress in 960MPa high strength steel welded box sections and unified model

Finite Element Analyses and Experiments on Welded Spherical Joints with Rectangular Tubes

Research on Residual Stress of a BS700 Butt-Welded Box Section and Its Influence on the Stability of Axial Compression Members

Effect of welding residual stress on the performance of CFST tubular joints

Numerical Study on Welding Residual Stress Distribution of Corrugated Steel Webs