Abstract:In this study, both the distribution of residual stress and welding deformation in a double-pass T-joint made of low-alloy ultra-high strength (UHS) quenched steel have been investigated experimentally and numerically. Using Abaqus software, the primary aim of this study is to develop an advanced computational approach incorporating a highly precise material model that accounts for solid-state phase transformation (SSPT) in the heat-affected zone (HAZ) and softening effect (SE) in the subcritical heat-affected zone (SCHAZ) to simulate residual stress and welding deformation in the double-pass T-joint. The predictions of welding thermal cycles, residual stress distribution, and welding deformation made by the finite element model have been validated against corresponding experimental results. When both SSPT and SE were considered in the finite element model, the predictions closely aligned with the experimental measurements. The experimental findings reveal that the maximum degree of softening in a T-joint subjected to double thermal cycles is more pronounced than in a T-joint subjected to a single thermal cycle. The simulation results indicate that SSPT significantly impacts both the magnitude and distribution of residual stress in the HAZ of the T-joint, while SE also can reduce the magnitude of longitudinal residual stress to a certain extent especially in SCHAZ. Furthermore, the simulation results suggest that SSPT moderately affects the distribution of longitudinal plastic strain in the double-pass T-joint, with minimal influence on angular distortion and transverse shrinkage. Additionally, the simulation results indicate that the SE has a limited impact on the welding deformation of the T-joint.

Effect of welding residual stress on the performance of CFST tubular joints

Effects of Residual Stress on the Stability of Multi-Welded Integral Stiffened Panels

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Effect of structural restraint caused by the stiffener on welding residual stress and deformation in thick-plate T-joints

FE analysis of residual stress and welding deformation of a low-alloy UHS quenched steel fillet joint

The Influence of Welding-Induced 3D Residual Stress and Distortion on the Ultimate Strength of Multi-Stiffened Thin Plate Structures under Cyclic Load

Evolution of welding residual stresses during cyclic tests in welded tubular joints

Welding-induced stresses and distortion in high-strength steel T-joints: Numerical and experimental study

Residual Stresses Simulation for Friction Stir Welded Joint

Numerical simulation of residual stress of butt-welded joint involved in complex column-beam welded structure

Research on stress distributions around welds of three-planar tubular Y-joints under out-of-plane bending moment

Effects of welding residual stresses on fatigue reliability assessment of a PC beam bridge with corrugated steel webs under dynamic vehicle loading

Cyclic Plasticity and ULCF Behavior of Steel Butt-Joints Considering Different Welding Methods

FEM Analysis of Residual Stress Induced by Repair Welding in SUS304 Stainless Steel Pipe Butt-Welded Joint

EXPERIMENTAL AND NUMERICAL ANALYSIS OF WELDING RESIDUAL STRESS IN HIGH STRENGTH STIFFENED PLATES

Numerical Study on Fatigue Behavior of Tubular Joints for Signal Support Structures

Influence of welding residual stress and welding method on fracture properties of welded joints

A physically consistent 2D residual stress model for approximating 3D effects in welding

Characterization of Fatigue Crack Growth Behavior in Welded Tubular T-joint

Numerical Analysis of Low Cycle Fatigue for Welded Joints Considering Welding Residual Stress and Plastic Damage under Combined Bending and Local Compressive Loads

Fatigue tests of multiplanar concrete-filled steel tubular KK-joints with inner ring stiffeners