Abstract:The mechanical interaction between welded panel and fixture has a remarkable influence on the distribution of weld induced residual stress and distortion.Unfortunately,the influence of fixture is not generally included in conventional numerical simulations of welding process.In the present study,it is proposed that the numerical models in which the mechanical interaction between welded panel and fixture is considered as contact pair in the finite element analysis(FEA) of welding process.This could make the FEA of welding process more scientific and accurate.The fixture constraint plays an important role in accurate modeling of welding process.In the simulations,various mechanical constraint boundary conditions in welding process were thought about to establish the relationships of the normal and tangential mechanical interactions between welded panel and fixture. In Free model,the fixture restraint was not considered.In Mech model,the displacements of nodes where welded panel contacted with fixture were restricted in x,y,z directions.Hard model and Tabular model were contact models which included the fixture.In the normal direction,once welded panel and fixture were in contact,the transmitted contact pressure could be infinite in Hard model.While data pairs of contact pressure vs over-closure or clearance were specified to define a piecewise-linear relationship in the normal direction in Tabular model.A penalty friction coefficient of 0.3 was applied in tangential direction in both Hard and Tabular models.Fixture and welded panel were separated and the contact relationships were removed after the welding process in both Hard and Tabular models. The simulation results of contact models including fixture were more accurate,compared to models containing only welded panel with rigid restrictions.The distortion mode of welded panels under different fixture constraint conditions corresponded well with experimental results.The differences between the distributions of transverse stresses on top and bottom surfaces of welded panel at the beginning of welding process had a crucial influence on the distortion mode of welded panel.

The Influence of Welding Mechanical Boundary Condition on the Residual Stress and Distortion of a Stiffened-Panel

Numerical simulation of influence factors of stress distribution of weld-bonded joint under peeling load

Modified Fourier-Galerkin Solution For Aerospace Skin-Stiffener Panels Subjected To Interface Force And Mixed Boundary Conditions

Elastic and Elastic-Plastic Threshold Stiffness of Stiffened Steel Plate Walls in Compression

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Effect of welding residual stress on the performance of CFST tubular joints

Effect of Welding Residual Stress on Plastic Buckling of Axially Compressed Cylindrical Shells with Patterned Welds

Experimental and numerical study on welding residual stress of U-rib stiffened plates

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

ESTABLISHMENT AND APPLICATION OF FIXTURE CONSTRAINT MODELS IN FINITE ELEMENT ANALYSIS OF WELDING PROCESS

Predicting Residual Distortion of Aluminum Alloy Stiffened Sheet after Friction Stir Welding by Numerical Simulation

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Influence of Welding Stress on the Ultimate Bearing Capacity of Steel Plane Shearing Wall(SPSW)with Opening

Study on FEM Numerical Simulation Method for the Welding Distortion

Influences of Initial Imperfection Due to Welding on the Ultimate Bending Moment of Ship Hull Girder

Review on finite element analysis of welding deformation and residual stress

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Influence of welding sequences and boundary conditions on residual stress and residual deformation in DH36 steel T-joint fillet welds

Study on CFRP-Strengthened Welded Steel Plates with Inclined Welds Considering Welding Residual Stress

Influence of restraint conditions on residual stress and distortion of 2219-T8 aluminum alloy TIG welded joints based on contour method

Experimental Research of Welding Residual Stress of Butt Welded Joint of Thick Steel Plate