Measurement and distribution models of residual stresses in welded stainless steel box sections

Yuanqing Wang,Huanxin Yuan,Yongjiu Shi,Ganping Shu,Dongfan Liao

DOI: https://doi.org/10.3969/j.issn.1001-0505.2013.05.014

2013-01-01

Abstract:Eight stainless steel box sections fabricated by welding, including austenitic grade S30408 and duplex grade S22253 , were sectioned into small strips by means of the wire-cutting technology. A mechanical Whittemore gage was used to measure the relieved residual strains, and the magnitudes and distributions of the welding residual stresses in the test specimens were obtained.The experimen-tal results show that the peak values of the tensile residual stress are always lower than the materials'nominal yield strength, reaching 80% and 60% of the yield strengths for grades S30408 and S22253 , respectively.Meanwhile, the peak compressive residual stress in plates decreases with the increase in the width-to-thickness ratio.Based upon the obtained measurement results and existing distribution models for carbon steel sections, the new accurate prediction models for residual stress distributions in welded stainless steel box sections were proposed.In general, the obtained test data and the proposed distribution models are suitable for further research on stability of fabricated struc-tural stainless steel members.