Abstract:High strength steels have been applied more and more widely in steel structures in the world. In China, Q420 steel angle members with the nominal yield strength of 420MPa have been applied in many steel structures especially in transmission towers. However, there is lack of study on its residual stress, which is one of the most important imperfections and has significant effects on the buckling behavior of steel members. The previous research works were only based on ordinary strength steels, whose yield strength is around 200MPa, and the distribution models of the residual stress in many countries' steel structures design codes are only applicable for ordinary strength steel members. Consequently, the study on the residual stress of high strength steel sections is quite necessary. Some measuring tests on high strength steel welded box and I sections have been conducted before, but no hot-rolled sections. In this paper, the residual stress measuring test for Q420 steel equal angle sections is conducted. Sectioning method is used, and there are 5 different sections with a total of 15 specimens were measured. Based on the test results, the characteristics of the residual stress distribution of Q420 high strength steel equal angles are analyzed, as well as the magnitudes of the compressive and tensile residual stresses. Besides, the test results were compared with the residual stress distribution of ordinary strength steels. Finally, the effects of the widththickness ratio of the angle leg and the steel strength are discussed. The test results can be used to establish new distribution models of Q420 high strength steel equal angles and it can be applied in the buckling analysis of such kind of angle members.

Investigation on residual stress in Q460 high strength steel welded box sections

Residual Stress of 460mpa High Strength Steel Welded Box Section: Experimental Investigation and Modeling

Experimental study on residual stress in 960MPa high strength steel welded box sections and unified model

EXPERIMENTAL AND UNIFIED MODEL INVESTIGATIONS ON RESIDUAL STRESS WITHIN HIGH STRENGTH STEEL WELDED I-SECTIONS

Experimental and Numerical Study of Membrane Residual Stress in Q690 High-Strength Steel Welded Box Section Compressed Member

Residual stresses of Q235 steel wallboard - Q460 high-strength steel column structural system

Measurement and distribution models of residual stresses in welded stainless steel box sections

Research on Residual Stress of a BS700 Butt-Welded Box Section and Its Influence on the Stability of Axial Compression Members

Residual Stress Of High Strength Steel Welded Sections

EXPERIMENTAL STUDY ON THE RESIDUAL STRESS OF Q420 LARGE-SECTION HOT-ROLLED AND GALVANIZED STEEL EQUAL LEG ANGLES

Study on the residual stress distribution of ultra-high–strength-steel welded sections

Experiments on the residual stress of 420MPA steel equal angles

Experimental and numerical investigation on the overall buckling behavior of Q460 high strength steel welded I-section columns

Mechanical Behavior of Q460 High-Strength Steel under Low-Cycle Fatigue Loading

Experimental and numerical study on welding residual stress of U-rib stiffened plates

RESIDUAL STRESS OF WELDED I SECTIONS FABRICATED FROM HIGH PERFORMANCE STEEL: EXPERIMENTAL INVESTIGATION AND MODELLING

Residual Stress Distributions in Welded Stainless Steel Sections

Investigation on residual stress of EQ56 high strength steel butt weld

Material properties and residual stresses of high strength steel hexagonal hollow sections

Experimental Research On Tensile Properties Of Q460 High Strength Steel Butt Welds

Overall buckling behavior of Q460 high strength steel welded box section columns under axial compression