Abstract:International Journal of Structural Stability and Dynamics, Ahead of Print. Given the increasing use of high-strength steels in building constructions, the stability design of high-strength steel beams has become a crucial consideration. However, the current standards of various countries are based on analyses and fittings derived from conventional steel, rendering them unsuitable for high-strength steel. Moreover, existing research indicates that these standards underestimate the ultimate load-bearing capacity of high-strength steel beams. A finite element model was established to investigate lateral torsional buckling in high-strength steel beams. The obtained results were then compared with test results from experiments conducted on Q460GJ and Q690 steel beams. The reliability and accuracy of the established finite element model were validated. Through parametric studies, the impact of depth-to-width ratio, boundary condition, and steel grade on the stability coefficient was evaluated. It was observed that at the same non-dimensional slenderness, an increase in the depth-to-width ratio or a reduction in support constraints led to a decrease in the stability coefficient. It should be noted that the steel grade had little effect on the stability coefficient. Comparisons with the current steel structure design codes, such as EN1993-1-1, GB50017-2017, JGJ/T483-2020, and ANSI/AISC360-22 revealed an underestimation of the stability coefficient for clamped high-strength steel beams under uniformly distributed loads. Based on finite element simulations, stability coefficients for high-strength Q460, Q690, and Q960 clamped beams were determined. Similar to the stability coefficient proposed in GB50017-2017 for the lateral buckling stability design of steel beams, a lateral buckling stability coefficient for high-strength steel clamped beams subjected to uniformly distributed loads was proposed.

STUDY ON THE STABILITY DESIGN METHOD OF HIGH STRENGTH STEEL ANGLE MEMBERS UNDER AXIAL COMPRESSION

A RESTUDY ON STABILITY OF STEEL BEAMS:HISTORICAL EVOLVEMENT AND DEFICIENCIES OF CHINESE CODE (Ⅰ)

Testing, Modelling and Design of Aluminium Alloy Single-Angle Members Connected by One Leg under Eccentric Compression

A review on buckling design research of high strength steel equal-leg angle members under axial compression

Experimental Study on Overall Buckling Behavior of Q420 High Strength Equal Angle Members under Axial Compression

Study on the Local Buckling Behavior of Steel Equal Angle Members under Axial Compression with the Steel Strength Variation

COMPARATIVE STUDY ON DESIGN METHODS FOR LOCAL STABILITY OF HIGH STRENGTH STEEL FLEXURAL MEMBERS IN DIFFERENT CODES

Numerical Study and Design Method for Lateral Torsional Buckling of High-Strength Steel Beams

Tests and Finite Element Analysis on the Local Buckling of 420 MPa Steel Equal Angle Columns under Axial Compression

Finite Element Analysis on the Local Buckling of High Strength Steel Members under Axial Compression

Experiments on the residual stress of 420MPA steel equal angles

Experiments on the local buckling of 420MPA steel equal angle columns under axial compression?

INVESTIGATION ON DESIGN METHOD OF OVERALL BUCKLING BEHAVIOUR FOR Q420 HIGH STRENGTH STEEL EQUAL-LEG ANGLE MEMBERS UNDER AXIAL COMPRESSION

Numerical study on the local buckling of 420MPA steel equal angle coloums under axial compression

FINITE ELEMENT ANALYSIS AND DESIGN METHOD STUDY ON THE LOCAL BUCKLING OF 460 MEGAPASCAL HIGH STRENGTH STEEL I-SECTION COLUMNS UNDER AXIAL COMPRESSION

Local Buckling of Steel Equal Angle Members with Normal and High Strengths

Experimental Study on Local Buckling of High Strength Steel I-section Stub Columns under Axial Compression

Experimental Study and Modeling of Residual Stresses of Q420 Large-Section Angles

Investigations and proposed design rules on bolted connections for high strength steel

Residual stress and compression buckling of large welded equal-leg steel angles

Column Buckling Tests of 420 Mpa High Strength Steel Single Equal Angles